Lines Matching refs:nodes
54 node may write to those sectors. This is used when a new nodes
60 Each node has to communicate with other nodes when starting or ending
70 Normally all nodes hold a concurrent-read lock on this device.
75 Messages can be broadcast to all nodes, and the sender waits for all
76 other nodes to acknowledge the message before proceeding. Only one
87 informs other nodes that the metadata has
94 informs other nodes that a resync is initiated or
104 informs other nodes that a device is being added to
128 The DLM LVB is used to communicate within nodes of the cluster. There
145 acknowledged by all nodes in the cluster. The BAST of the resource
151 1. receive status - all nodes have concurrent-reader lock on "ack"::
231 other nodes from writing anywhere on the array.
234 environment when a resync is performed, it needs to tell other nodes
241 other nodes and other nodes remove the corresponding entry from the
253 acknowledged by all other nodes.
258 For adding a new device, it is necessary that all nodes "see" the new
264 3. Other nodes issue kobject_uevent_env with uuid and slot number
268 5. Other nodes issue either of the following depending on whether
273 6. Other nodes drop lock on "no-new-devs" (CR) if device is found
279 10. Other nodes get the information whether a disk is added or not
289 6.1 join(nodes) and leave()
295 Only the first 'nodes' nodes in the cluster can use the array.
301 Range is from 0 to nodes-1.
328 message to all other nodes, otherwise metadata_update_cancel()
362 the array. It causes a REMOVE message to be send to other nodes.
367 This sends a RE_ADD message to all other nodes and then
376 nodes are using the raid which is achieved by lock all bitmap