Lines Matching refs:dev_err
245 dev_err(&ts->client->dev, "%s failed\n", __func__); in bu21013_gpio_irq()
269 dev_err(&client->dev, "BU21013_RESET reg write failed\n"); in bu21013_init_chip()
277 dev_err(&client->dev, "BU21013_SENSOR_0_7 reg write failed\n"); in bu21013_init_chip()
284 dev_err(&client->dev, "BU21013_SENSOR_8_15 reg write failed\n"); in bu21013_init_chip()
291 dev_err(&client->dev, "BU21013_SENSOR_16_23 reg write failed\n"); in bu21013_init_chip()
299 dev_err(&client->dev, "BU21013_POS_MODE1 reg write failed\n"); in bu21013_init_chip()
310 dev_err(&client->dev, "BU21013_POS_MODE2 reg write failed\n"); in bu21013_init_chip()
318 dev_err(&client->dev, "BU21013_CLK_MODE reg write failed\n"); in bu21013_init_chip()
326 dev_err(&client->dev, "BU21013_IDLE reg write failed\n"); in bu21013_init_chip()
333 dev_err(&client->dev, "BU21013_INT_MODE reg write failed\n"); in bu21013_init_chip()
341 dev_err(&client->dev, "BU21013_FILTER reg write failed\n"); in bu21013_init_chip()
348 dev_err(&client->dev, "BU21013_TH_ON reg write failed\n"); in bu21013_init_chip()
355 dev_err(&client->dev, "BU21013_TH_OFF reg write failed\n"); in bu21013_init_chip()
362 dev_err(&client->dev, "BU21013_GAIN reg write failed\n"); in bu21013_init_chip()
369 dev_err(&client->dev, "BU21013_OFFSET_MODE reg write failed\n"); in bu21013_init_chip()
379 dev_err(&client->dev, "BU21013_XY_EDGE reg write failed\n"); in bu21013_init_chip()
386 dev_err(&client->dev, "BU21013_REG_DONE reg write failed\n"); in bu21013_init_chip()
418 dev_err(&client->dev, "i2c smbus byte data not supported\n"); in bu21013_probe()
423 dev_err(&client->dev, "No IRQ set up\n"); in bu21013_probe()
438 dev_err(&client->dev, "device memory alloc failed\n"); in bu21013_probe()
475 dev_err(&client->dev, "failed to initialize MT slots"); in bu21013_probe()
481 dev_err(&client->dev, "regulator_get failed\n"); in bu21013_probe()
487 dev_err(&client->dev, "regulator enable failed\n"); in bu21013_probe()
493 dev_err(&client->dev, "failed to install power off handler\n"); in bu21013_probe()
502 dev_err(&client->dev, "failed to get CS GPIO\n"); in bu21013_probe()
510 dev_err(&client->dev, in bu21013_probe()
521 dev_err(&client->dev, "failed to get INT GPIO\n"); in bu21013_probe()
531 dev_err(&client->dev, "error in bu21013 config\n"); in bu21013_probe()
539 dev_err(&client->dev, "request irq %d failed\n", in bu21013_probe()
546 dev_err(&client->dev, "failed to register input device\n"); in bu21013_probe()
590 dev_err(&client->dev, in bu21013_resume()
597 dev_err(&client->dev, in bu21013_resume()