Lines Matching refs:instruction
23 Each configuration file uses very simple instruction semantics and a few
27 - Each line of the configuration file contains exactly one instruction.
31 - Each "section" is started by the "SECTION" instruction.
32 - The "SECTION" instruction has the following semantics:
43 - A "SECTION" must be immediatelly followed by a "TAG" instruction.
44 - The "TAG" instruction has the following semantics:
49 - After a "TAG" instruction, any of the following instructions may follow
53 - This instruction does nothing
62 - i.MX28-specific instruction!
67 - i.MX28-specific instruction!
82 - See JUMP instruction above, as the operation is exactly the same with
83 one difference. The CALL instruction does allow returning into the
104 the ID number used by "LOAD DCD" instruction.
108 the 'n' suffix of the instruction:
140 - This instruction does nothing.
148 produce a letter on the Debug UART for each instruction it started processing.
152 T -- TAG instruction
153 N -- NOOP instruction
154 L -- LOAD instruction
155 F -- FILL instruction
156 J -- JUMP instruction
157 C -- CALL instruction
158 M -- MODE instruction