Lines Matching refs:to
31 Select this to enable support for the axp152 pmic found on most
40 Select this to enable support for the axp209 pmic found on most
49 Select this to enable support for the axp221/axp223 pmic found on most
58 Select this to enable support for the axp305 pmic found on most
67 Say y here to enable support for the axp809 pmic found on A80 boards.
75 Say y here to enable support for the axp818 pmic found on
82 Select this to enable support for the SY8106A pmic found on some
93 Set the voltage (mV) to program the axp pmic dcdc1 at, set to 0 to
96 sdcard interfaces, etc. On most boards dcdc1 is undervolted to 3.0V to
110 Set the voltage (mV) to program the axp pmic dcdc2 at, set to 0 to
128 Set the voltage (mV) to program the axp pmic dcdc3 at, set to 0 to
147 Set the voltage (mV) to program the axp pmic dcdc4 at, set to 0 to
161 Set the voltage (mV) to program the axp pmic dcdc5 at, set to 0 to
173 Set the voltage (mV) to program the axp pmic aldo1 at, set to 0 to
175 On A31 boards aldo1 is often used to power the wifi module.
189 Set the voltage (mV) to program the axp pmic aldo2 at, set to 0 to
205 Set the voltage (mV) to program the axp pmic aldo3 at, set to 0 to
219 The AXP can slowly ramp up voltage to reduce the inrush current when
222 "axp pmic (a)ldo3 inrush quirk" below to enable a slew rate to limit
228 Tries to reach the next voltage setting near instantaneously. Measurements
262 Set the voltage (mV) to program the axp pmic aldo4 at, set to 0 to
271 Set the voltage (mV) to program the axp pmic dldo1 at, set to 0 to
273 to power the ethernet phy. On A23, A33 and A80 boards this is often
274 used to power the wifi.
282 Set the voltage (mV) to program the axp pmic dldo2 at, set to 0 to
291 Set the voltage (mV) to program the axp pmic dldo3 at, set to 0 to
299 Set the voltage (mV) to program the axp pmic dldo4 at, set to 0 to
307 Set the voltage (mV) to program the axp pmic eldo1 at, set to 0 to
315 Set the voltage (mV) to program the axp pmic eldo2 at, set to 0 to
324 Set the voltage (mV) to program the axp pmic eldo3 at, set to 0 to
325 disable eldo3. On some A31(s) tablets it might be used to supply
335 Set the voltage (mV) to program the axp pmic fldo1 at, set to 0 to
345 Set the voltage (mV) to program the axp pmic fldo2 at, set to 0 to
354 Set the voltage (mV) to program the axp pmic fldo3 at, set to 0 to
362 Enable to turn on axp pmic sw.
369 Set the voltage (mV) to program the SY8106A pmic VOUT1. This
370 is typically used to power the VDD-CPU and should be 1200mV.