1menu "ClearFog configuration"
2	depends on TARGET_CLEARFOG
3
4config TARGET_CLEARFOG_BASE
5	bool "Use ClearFog Base static configuration"
6	help
7	  Use the ClearFog Base as the static configuration instead of the
8	  default which uses the ClearFog Pro.
9
10	  Runtime board detection is always attempted and used if available. The
11	  static configuration is used as a fallback in cases where runtime
12	  detection is disabled, is not available in hardware, or otherwise fails.
13
14	  Only newer revisions of the ClearFog product line support runtime
15	  detection via additional EEPROM hardware. This option enables selecting
16	  the Base variant for older hardware revisions.
17
18config CLEARFOG_CON3_SATA
19	bool "Use CON3 slot in SATA mode"
20	help
21	  Use the CON3 port with SATA protocol instead of the default PCIe.
22	  The ClearFog port allows usage of either mSATA or miniPCIe
23	  modules, but the desired protocol must be configured at build
24	  time since it affects the SerDes topology layout.
25
26config CLEARFOG_CON2_SATA
27	bool "Use CON2 slot in SATA mode"
28	depends on !TARGET_CLEARFOG_BASE
29	help
30	  Use the CON2 port with SATA protocol instead of the default PCIe.
31	  The ClearFog port allows usage of either mSATA or miniPCIe
32	  modules, but the desired protocol must be configured at build
33	  time since it affects the SerDes topology layout.
34
35config CLEARFOG_SFP_25GB
36	bool "Enable 2.5 Gbps mode for SFP"
37	help
38	  Set the SFP module connection to support 2.5 Gbps transfer speed for the
39	  SGMII connection (requires a supporting SFP). By default, transfer speed
40	  of 1.25 Gbps is used, suitable for a more common 1 Gbps SFP module.
41
42config ENV_SIZE
43	hex "Environment Size"
44	default 0x10000
45
46config ENV_OFFSET
47	hex "Environment offset"
48	default 0xF0000
49
50config ENV_SECT_SIZE
51	hex "Environment Sector-Size"
52	# Use SPI flash erase block size of 4 KiB
53	default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI || MVEBU_SPL_BOOT_DEVICE_SATA
54	# Use optimistic 64 KiB erase block, will vary between actual media
55	default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC || MVEBU_SPL_BOOT_DEVICE_UART
56
57config SYS_SPI_U_BOOT_OFFS
58	hex "address of u-boot payload in SPI flash"
59	default 0x20000
60	depends on MVEBU_SPL_BOOT_DEVICE_SPI
61
62endmenu
63