| /linux/Documentation/translations/zh_CN/infiniband/ |
| A D | opa_vnic.rst | 78 0-7 L4 type (=0x78 ETHERNET)
87 16-31 L4 头
104 L4头字段包含VNIC端口所属的虚拟以太网交换机ID。在接收端，该字段用于将收
|
| /linux/drivers/cpufreq/ |
| A D | s5pv210-cpufreq.c | 110 L0, L1, L2, L3, L4, enumerator
129 {0, L4, 100*1000},
161 [L4] = {
268 if ((index == L4) || (priv_index == L4)) in s5pv210_target()
456 if (index != L4) { in s5pv210_target()
|
| /linux/arch/riscv/lib/ |
| A D | tishift.S | 37 blez a5, .L4
46 .L4: label
|
| /linux/Documentation/devicetree/bindings/arm/omap/ |
| A D | l4.txt | 1 L4 interconnect bindings
3 These bindings describe the OMAP SoCs L4 interconnect bus.
|
| /linux/arch/m68k/lib/ |
| A D | udivsi3.S | 108 L4: lsrl IMM (1), d1 /* shift divisor */ label
111 jcc L4
|
| /linux/arch/arm/boot/dts/ |
| A D | gemini-wbd111.dts | 51 label = "wbd111:green:L4";
57 label = "wbd111:red:L4";
|
| A D | gemini-wbd222.dts | 50 label = "wbd111:green:L4";
56 label = "wbd111:red:L4";
|
| A D | omap4460.dtsi | 88 /* Only some L4 CFG interconnect ranges are different on 4460 */
|
| A D | omap5-l4-abe.dtsi | 17 /* CPU to L4 ABE mapping */
53 /* L3 to L4 ABE mapping */
|
| A D | omap4-l4-abe.dtsi | 17 /* CPU to L4 ABE mapping */
53 /* L3 to L4 ABE mapping */
|
| /linux/arch/xtensa/lib/ |
| A D | memset.S | 88 bbci.l a4, 1, .L4
92 .L4: label
|
| A D | memcopy.S | 162 bbsi.l a4, 1, .L4
171 bbsi.l a4, 1, .L4
174 .L4: label
|
| A D | usercopy.S | 182 bbci.l a4, 1, .L4
188 .L4: label
|
| /linux/Documentation/infiniband/ |
| A D | opa_vnic.rst | 69 0-7 L4 type (=0x78 ETHERNET)
78 16-31 L4 header
97 The L4 header field contains the virtual Ethernet switch id the VNIC port
|
| /linux/Documentation/networking/device_drivers/ethernet/microsoft/ |
| A D | netvsc.rst | 29 For TCP & UDP, we can switch hash level between L3 and L4 by ethtool
31 hash level is L4. We currently only allow switching TX hash level
34 On Azure, fragmented UDP packets have high loss rate with L4
|
| /linux/arch/sparc/net/ |
| A D | bpf_jit_64.h | 24 #define L4 0x14 macro
|
| /linux/Documentation/bpf/ |
| A D | prog_sk_lookup.rst | 84 * L4 protocol identifier (``IPPROTO_TCP`` or ``IPPROTO_UDP``),
86 * source and destination L4 port,
|
| /linux/arch/csky/abiv1/ |
| A D | memcpy.S | 78 .L4: label
84 jbt .L4
|
| /linux/Documentation/networking/device_drivers/ethernet/freescale/dpaa2/ |
| A D | ethernet-driver.rst | 182 traffic based on a 5-tuple key: src IP, dst IP, IP proto, L4 src port,
183 L4 dst port. No user configuration is supported for now.
|
| /linux/Documentation/networking/device_drivers/ethernet/aquantia/ |
| A D | atlantic.rst | 263 3. 8 L3/L4 5-Tuple rules
281 - Locations 32 - 39 for L3/L4 5-tuple filters (locations 32, 36 for IPv6)
283 The L3/L4 5-tuple (protocol, source and destination IP address, source and
360 RX Flow L3/L4 rule may be used.
|
| /linux/Documentation/locking/ |
| A D | rt-mutex-design.rst | 139 Mutexes: L1, L2, L3, L4
147 D owns L4
148 E blocked on L4
152 E->L4->D->L3->C->L2->B->L1->A
166 E->L4->D->L3->C->L2-+
185 E->L4->D->L3->C-+
|
| /linux/drivers/pinctrl/aspeed/ |
| A D | pinctrl-aspeed-g4.c | 1471 #define L4 177 macro
1472 SIG_EXPR_LIST_DECL_SINGLE(L4, GPIOW1, GPIOW1, SIG_DESC_SET(SCUA0, 25));
1473 SIG_EXPR_LIST_DECL_SINGLE(L4, ADC1, ADC1);
1474 PIN_DECL_(L4, SIG_EXPR_LIST_PTR(L4, GPIOW1), SIG_EXPR_LIST_PTR(L4, ADC1));
1475 FUNC_GROUP_DECL(ADC1, L4);
2055 ASPEED_PINCTRL_PIN(L4),
2494 ASPEED_SB_PINCONF(PIN_CONFIG_BIAS_PULL_DOWN, L4, L4, SCUA8, 5),
2495 ASPEED_SB_PINCONF(PIN_CONFIG_BIAS_DISABLE, L4, L4, SCUA8, 5),
|
| /linux/Documentation/devicetree/bindings/devfreq/ |
| A D | exynos-bus.txt | 178 |L4| 200000 |825000 |
196 |L4 |134000 |134000 |200000 |200000 | ||1000000 |
|
| /linux/arch/arm64/boot/dts/qcom/ |
| A D | sm8250-sony-xperia-edo.dtsi | 184 /* L4 - lmx.lvl (ARC) */
392 /* L3 & L4 are unused. */
|
| /linux/Documentation/devicetree/bindings/bus/ |
| A D | ti-sysc.yaml | 15 using Arteris NoC, and L4 interconnect using Sonics s3220. This module
|