Searched refs:Shutdown (Results 1 – 25 of 31) sorted by relevance
12
34 SH (en_global_shutdown) and SP bits of the Primary Source and Shutdown42 1 0 Active/Shutdown43 1 1 Inactive/Shutdown89 bit of the Primary Source and Shutdown Register.99 Shutdown Register.
28 Shutdown Order :- Digital Mute --> Output PGA --> Mixers --> DAC45 Shutdown Order - ADC --> Mixers --> Input PGA
85 "crashed" Shutdown because of a HW or SW crash.86 "halted" Shutdown because of a halt command.87 "poweroff" Shutdown because of a poweroff command.88 "restart" Shutdown because of a restart command.
10 Description: Shutdown time in us. Board is powered off if the button is pressed
47 sensors, limits can be set through the appropriate Overtemperature Shutdown50 temperature gets higher then the Overtemperature Shutdown value; it stays on
46 when the Overtemperature Shutdown limit is crossed; it is triggered again50 is above the Overtemperature Shutdown value. Measurements are guaranteed
22 set through the Overtemperature Shutdown register and Hysteresis register. The
142 Overtemperature Shutdown register and Hysteresis register. Each value can be145 gets higher then the Overtemperature Shutdown value; it stays on until
46 drops below the HOT Hysteresis. The Overtemperature Shutdown (OS) limits
245 - Volt sensor: Shutdown if alarm persist for more than 4 seconds (RW)246 - Temp sensor: Shutdown if temp is over the shutdown threshold (RW)320 Shutdown if alarm persist for more than 4 seconds (RW)
49 when the Overtemperature Shutdown limit is crossed; it is triggered again
104 Overtemperature Shutdown limit is crossed; it is triggered again as soon as108 is above the Overtemperature Shutdown value. The driver sets the112 temperature gets higher then the Overtemperature Shutdown value; it stays
77 the temperature gets higher than the Overtemperature Shutdown value; it stays
60 the temperature gets higher than the Overtemperature Shutdown value; it stays
37 * Shutdown:50 * Shutdown: temp1_emergency and temp1_emergency_hyst.
26 description: GPIO spec for Powerdown/Shutdown line to use
70 SHDWC Shutdown Controller101 SHDWC SAMA5D2-Compatible Shutdown Controller
177 u64 Shutdown; member
154 loongson_sysconf.poweroff_addr = boot_p->reset_system.Shutdown; in prom_lefi_init_env()
62 Shutdown mode. As the line is active low, it should be marked
1345 static u32 MT2063_SoftwareShutdown(struct mt2063_state *state, u8 Shutdown) in MT2063_SoftwareShutdown() argument1350 if (Shutdown == 1) in MT2063_SoftwareShutdown()1359 if (Shutdown != 1) { in MT2063_SoftwareShutdown()
250 - Shutdown firewall.
142 Shutdown KSMBD
122 or Xilinx Dynamic Function eXchange AIX Shutdown Manager.
315 - description: Shutdown acknowledge interrupt
Completed in 36 milliseconds