| /linux/Documentation/sound/designs/ |
| A D | powersave.rst | 5 AC97 and HD-audio drivers have the automatic power-saving mode.
9 With the automatic power-saving, the driver turns off the codec power
15 The time-out for automatic power-off can be specified via ``power_save``
17 the time-out value in seconds. 0 means to disable the automatic
27 automatic power-save mode with 10 seconds, write to
|
| /linux/Documentation/hwmon/ |
| A D | dell-smm-hwmon.rst | 41 pwm1_enable WO Enable or disable automatic BIOS fan
49 Disabling automatic BIOS fan control
56 There is experimental support for disabling automatic BIOS fan
59 (writing ``2`` enables automatic BIOS control again). Even if you have
61 automatic fan control at the same time and, notwithstanding the name,
62 ``pwm1_enable`` sets automatic control for all fans.
65 enabling and disabling automatic BIOS fan control are not whitelisted
|
| A D | adt7470.rst | 40 automatic fan pwm control to set the fan speed. The driver will not read the
51 determining an optimal configuration for the automatic PWM control.
93 order for the automatic pwm algorithm to run. This was the case for earlier
|
| A D | asc7621.rst | 91 Using temperature information from these four zones, an automatic fan speed
204 to the point where the automatic thermal control circuit starts
211 2 Fan on automatic control and will run at the minimum pwm
213 3 Fan on automatic control but will be off if the
|
| A D | vt1211.rst | 55 This chip also provides manual and automatic control of fan speeds (according
56 to the datasheet). The driver only supports automatic control since the manual
58 get manual mode to work at all! Be aware that automatic mode hasn't been
177 PWM controller in automatic mode. There is only a single controller that
|
| A D | dme1737.rst | 175 1-3 can be configured to operate either in manual or automatic mode by setting
179 appropriate PWM attribute. In automatic mode, the PWM attribute returns the
183 In automatic mode, the chip supports the setting of the PWM ramp rate which
312 - 2: automatic mode
321 when the PWM is in automatic mode.
|
| A D | lm63.rst | 81 PWM modes: manual and automatic. Automatic mode is not fully implemented yet
87 but will return 'old' values. Values in the automatic fan control lookup table
|
| /linux/Documentation/userspace-api/media/v4l/ |
| A D | ext-ctrls-rf-tuner.rst | 40 automatic mode bandwidth configuration is performed by the driver.
50 Enables/disables LNA automatic gain control (AGC)
53 Enables/disables mixer automatic gain control (AGC)
56 Enables/disables IF automatic gain control (AGC)
|
| A D | ext-ctrls-camera.rst | 29 Enables automatic adjustments of the exposure time and/or iris
42 - Automatic exposure time, automatic iris aperture.
65 Determines the automatic exposure compensation, it is effective only
153 Enables continuous automatic focus adjustments. The effect of manual
163 Aborts automatic focusing started with ``V4L2_CID_AUTO_FOCUS_START``
171 The automatic focus status. This is a read-only control.
212 - Normal distance range, limited for best automatic focus
272 Sets white balance to automatic, manual or a preset. The presets
352 Enables or disables automatic ISO sensitivity adjustments.
404 automatic exposure is based on an average scene brightness. To
[all …]
|
| /linux/drivers/net/wireless/intersil/orinoco/ |
| A D | hw.h | 30 int orinoco_get_bitratemode(int bitrate, int automatic);
31 void orinoco_get_ratemode_cfg(int ratemode, int *bitrate, int *automatic);
|
| A D | hw.c | 30 int automatic; member
430 int orinoco_get_bitratemode(int bitrate, int automatic) in orinoco_get_bitratemode() argument
441 (bitrate_table[i].automatic == automatic)) { in orinoco_get_bitratemode()
449 void orinoco_get_ratemode_cfg(int ratemode, int *bitrate, int *automatic) in orinoco_get_ratemode_cfg() argument
454 *automatic = bitrate_table[ratemode].automatic; in orinoco_get_ratemode_cfg()
|
| /linux/net/8021q/ |
| A D | Kconfig | 28 automatic propagation of registered VLANs to switches.
38 automatic propagation of registered VLANs to switches; it
|
| /linux/drivers/staging/unisys/Documentation/ABI/ |
| A D | sysfs-platform-visorchipset | 8 s-Par's automatic installation progress screen when an error
17 Description: used to set the value of the progress bar on the s-Par automatic
27 s-Par's automatic installation progress screen. Setting this
|
| /linux/drivers/net/ethernet/qualcomm/emac/ |
| A D | emac-ethtool.c | 174 pause->autoneg = adpt->automatic ? AUTONEG_ENABLE : AUTONEG_DISABLE; in emac_get_pauseparam()
184 adpt->automatic = pause->autoneg == AUTONEG_ENABLE; in emac_set_pauseparam()
|
| /linux/Documentation/userspace-api/ |
| A D | sysfs-platform_profile.rst | 8 conditions by some automatic mechanism (which may very well live outside
16 API for selecting the platform profile of these automatic mechanisms.
|
| /linux/Documentation/devicetree/bindings/sound/ |
| A D | cs35l33.txt | 76 automatic updating is enabled.
84 allowed to increase to a higher voltage when using VPhg automatic
89 - cirrus,vp-hg-va : VA calculation reference for automatic VPhg tracking
|
| /linux/sound/ac97/ |
| A D | Kconfig | 11 drivers which benefit from the AC97 automatic probing should "select"
|
| /linux/drivers/staging/pi433/ |
| A D | rf69_enum.h | 60 automatic, enumerator
|
| /linux/Documentation/devicetree/bindings/serial/ |
| A D | socionext,uniphier-uart.yaml | 26 description: enable automatic flow control support.
|
| /linux/Documentation/devicetree/bindings/watchdog/ |
| A D | da9062-wdt.txt | 11 Only use this option if you can't use the watchdog automatic suspend
|
| /linux/Documentation/ABI/stable/ |
| A D | sysfs-bus-fsl-mc | 16 disable the DPRC IRQs on which automatic rescan
|
| /linux/Documentation/driver-api/ |
| A D | ptp.rst | 106 …- LPF settings (bandwidth, phase limiting, automatic holdover, physical layer assist (per ITU-T G.…
108 … - Lock to GNSS input, automatic switching between GNSS and user-space PHC control (optional)
|
| /linux/drivers/net/wireless/ti/ |
| A D | Kconfig | 18 # keep last for automatic dependencies
|
| /linux/Documentation/dev-tools/ |
| A D | kmemleak.rst | 51 start the automatic memory scanning thread (default)
53 stop the automatic memory scanning thread
55 set the automatic memory scanning period in seconds
56 (default 600, 0 to stop the automatic scanning)
|
| /linux/drivers/w1/ |
| A D | Kconfig | 25 either due to automatic or requested search.
|