Searched refs:eoc (Results 1 – 13 of 13) sorted by relevance
| /linux/drivers/power/supply/ |
| A D | max8998_charger.c | 118 if (pdata->eoc >= 10 && pdata->eoc <= 45) { in max8998_battery_probe()
120 (pdata->eoc / 5 - 2) << 5, 0x7 << 5); in max8998_battery_probe()
121 } else if (pdata->eoc == 0) { in max8998_battery_probe()
|
| /linux/Documentation/devicetree/bindings/power/supply/ |
| A D | ti,lp8727.yaml | 38 eoc-level:
78 eoc-level = /bits/ 8 <0>;
85 eoc-level = /bits/ 8 <1>;
|
| /linux/Documentation/devicetree/bindings/mfd/ |
| A D | max14577.txt | 28 - maxim,eoc-uamp : Current in uA for End-Of-Charge mode;
99 maxim,eoc-uamp = <50000>;
144 maxim,eoc-uamp = <7500>;
|
| /linux/drivers/net/wireless/broadcom/brcm80211/brcmfmac/ |
| A D | firmware.c | 166 char *eoc, *sol; in brcmf_nvram_handle_comment() local
169 eoc = strchr(sol, '\n'); in brcmf_nvram_handle_comment()
170 if (!eoc) { in brcmf_nvram_handle_comment()
171 eoc = strchr(sol, '\0'); in brcmf_nvram_handle_comment()
172 if (!eoc) in brcmf_nvram_handle_comment()
179 nvp->pos += (eoc - sol) + 1; in brcmf_nvram_handle_comment()
|
| /linux/drivers/iio/adc/ |
| A D | at91-sama5d2_adc.c | 691 u32 *eoc) in at91_adc_irq_status() argument
695 *eoc = at91_adc_readl(st, EOC_ISR); in at91_adc_irq_status()
697 *eoc = *status; in at91_adc_irq_status()
704 *eoc = at91_adc_readl(st, EOC_IMR); in at91_adc_irq_mask()
706 *eoc = *status; in at91_adc_irq_mask()
1236 u32 status, imr, eoc = 0, eoc_imr; in at91_adc_trigger_handler_nodma() local
1242 while (((eoc & mask) != mask) && timeout) { in at91_adc_trigger_handler_nodma()
1243 at91_adc_irq_status(st, &status, &eoc); in at91_adc_trigger_handler_nodma()
1480 u32 status, eoc, imr, eoc_imr; in at91_adc_interrupt() local
1484 at91_adc_irq_status(st, &status, &eoc); in at91_adc_interrupt()
[all …]
|
| /linux/include/linux/mfd/ |
| A D | max8998.h | 101 int eoc; member
|
| /linux/arch/arm64/boot/dts/qcom/ |
| A D | pmk8350.dtsi | 41 interrupt-names = "eoc-int-en-set";
|
| /linux/drivers/net/ethernet/ti/ |
| A D | tlan.c | 1349 int eoc = 0; in tlan_handle_tx_eof() local
1374 eoc = 1; in tlan_handle_tx_eof()
1388 if (eoc) { in tlan_handle_tx_eof()
1482 int eoc = 0; in tlan_handle_rx_eof() local
1503 eoc = 1; in tlan_handle_rx_eof()
1543 if (eoc) { in tlan_handle_rx_eof()
|
| /linux/drivers/block/ |
| A D | floppy.c | 2320 int eoc; in rw_interrupt() local
2338 eoc = 1; in rw_interrupt()
2340 eoc = 0; in rw_interrupt()
2349 reply_buffer[R_SECTOR] - raw_cmd->cmd[SECTOR] + eoc) << raw_cmd->cmd[SIZECODE] >> 2; in rw_interrupt()
2361 pr_info("heads=%d eoc=%d\n", heads, eoc); in rw_interrupt()
|
| /linux/arch/arm/boot/dts/ |
| A D | exynos3250-monk.dts | 107 maxim,eoc-uamp = <7500>;
|
| A D | exynos3250-rinato.dts | 108 maxim,eoc-uamp = <7500>;
|
| /linux/drivers/net/wireless/cisco/ |
| A D | airo.c | 991 unsigned int eoc: 1; member
1993 ai->txfids[0].tx_desc.eoc = 1; in mpi_send_packet()
2507 ai->txfids[i-1].tx_desc.eoc = 1; /* Last descriptor has EOC set */ in mpi_init_descriptors()
2623 ai->txfids[i-1].tx_desc.eoc = 1; /* Last descriptor has EOC set */ in mpi_map_card()
|
| /linux/drivers/net/ethernet/chelsio/cxgb4/ |
| A D | cxgb4_main.c | 4123 u8 soc = 0, eoc = 0; in adap_config_hma() local
4127 eoc = (i == ncmds - 1) ? 1 : 0; in adap_config_hma()
4143 FW_HMA_CMD_SOC_V(soc) | FW_HMA_CMD_EOC_V(eoc)); in adap_config_hma()
|
Completed in 59 milliseconds