Searched refs:tied (Results 1 – 25 of 50) sorted by relevance
12
| /linux/Documentation/devicetree/bindings/soc/qcom/ |
| A D | qcom,smd.txt | 61 In turn, subnodes of the "edges" represent devices tied to SMD channels on that
69 Definition: a list of channels tied to this device, used for matching
75 "rpm" subsystem. For the "rpm" subsystem we have a device tied to the
|
| A D | qcom,glink.txt | 41 Each subnode of the GLINK node represent function tied to a virtual
49 Definition: a list of channels tied to this function, used for matching
|
| /linux/drivers/gpu/drm/nouveau/nvkm/engine/disp/ |
| A D | vga.c | 166 u32 tied = nvkm_rd32(device, 0x001084) & 0x10000000; in nvkm_rdvgaowner() local
167 if (tied == 0) { in nvkm_rdvgaowner()
|
| /linux/Documentation/driver-api/nvdimm/ |
| A D | security.rst | 93 An key with the current passphrase payload that is tied to the nvdimm should be
101 An key with the current passphrase payload that is tied to the nvdimm should be
115 An encrypted-key with the current user passphrase that is tied to the nvdimm
|
| /linux/Documentation/security/ |
| A D | landlock.rst | 69 A domain is a read-only ruleset tied to a set of subjects (i.e. tasks'
72 domain. Indeed, once in a domain, each rule is tied to a layer level. To
|
| /linux/Documentation/spi/ |
| A D | spi-lm70llp.rst | 66 collector is tied to VCC.
72 hand, the transistor is cut off and the voltage tied to it's collector is
|
| /linux/Documentation/devicetree/bindings/iio/adc/ |
| A D | ti,ads8688.yaml | 26 REFSEL input tied low to enable the internal reference.
|
| A D | adi,ad7606.yaml | 78 this pin is tied to a logic high, the analog input range is ±10V for
79 all channels. If this pin is tied to a logic low, the analog input range
|
| /linux/security/landlock/ |
| A D | Kconfig | 12 directory, etc.) tied to a file hierarchy. Such policy can be
|
| /linux/Documentation/devicetree/bindings/mmc/ |
| A D | sdhci-atmel.txt | 20 For instance on SAMA5D2, the pin is usually tied to the GND with a resistor
|
| /linux/Documentation/devicetree/bindings/mfd/ |
| A D | richtek,rt4831.yaml | 36 Some usage directly tied this pin to follow VIO 1.8V power on sequence.
|
| A D | aspeed-lpc.yaml | 100 The UARTs present in the ASPEED SoC can have their resets tied to the reset
|
| /linux/drivers/net/wireless/microchip/wilc1000/ |
| A D | Kconfig | 37 immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to
|
| /linux/Documentation/userspace-api/media/v4l/ |
| A D | pixfmt-meta-intel-ipu3.rst | 50 Both 3A statistics and pipeline parameters described here are closely tied to
|
| /linux/arch/powerpc/boot/dts/ |
| A D | xpedite5200.dts | 431 cle-line = <0x8>; /* CLE tied to A3 */
432 ale-line = <0x10>; /* ALE tied to A4 */
|
| A D | xpedite5200_xmon.dts | 435 cle-line = <0x8>; /* CLE tied to A3 */
436 ale-line = <0x10>; /* ALE tied to A4 */
|
| /linux/Documentation/driver-api/media/drivers/ |
| A D | cx88-devel.rst | 66 GPIO 16(I believe) is tied to the IR port (if present).
|
| /linux/Documentation/devicetree/bindings/spi/ |
| A D | spi-davinci.txt | 23 lines can be tied to the interrupt controller. Set this
|
| /linux/Documentation/virt/kvm/arm/ |
| A D | psci.rst | 17 a given guest is tied to a particular PSCI revision (unlikely), or if
|
| /linux/arch/arm/boot/dts/ |
| A D | armada-388-clearfog.dtsi | 193 * address pins tied low, which takes addresses 0x50 and 0x51.
|
| A D | sun7i-a20-bananapi-m1-plus.dts | 262 /* VBUS on usb host ports are tied to DC5V and therefore always on */
|
| /linux/Documentation/fb/ |
| A D | ep93xx-fb.rst | 127 the VIDSCRNPAGE (framebuffer physical offset) to be tied low. There is
|
| /linux/drivers/clk/samsung/ |
| A D | Kconfig | 93 status of the certains clocks from SoC, but it could also be tied to
|
| /linux/Documentation/networking/device_drivers/ethernet/pensando/ |
| A D | ionic.rst | 93 reflects the rx-usecs value as they are tied together on the same interrupt.
|
| /linux/Documentation/driver-api/ |
| A D | ioctl.rst | 238 is not tied to a physical device or constrained by the file system
248 that is not tied to a file descriptor.
|
Completed in 30 milliseconds
12