Searched refs:tuned (Results 1 – 25 of 45) sorted by relevance
12
| /linux/Documentation/userspace-api/media/dvb/ |
| A D | frontend-stat-properties.rst | 109 channel/transponder is tuned.
137 channel/transponder is tuned.
166 channel/transponder is tuned.
194 channel/transponder is tuned.
215 channel/transponder is tuned.
|
| A D | fe-read-status.rst | 37 tuned. The ioctl takes a pointer to an integer where the status will be
|
| /linux/Documentation/ABI/testing/ |
| A D | sysfs-bus-iio-adc-stm32 | 6 (e.g. timers, pwm or exti gpio). Then, it can be tuned to start
|
| /linux/include/media/drv-intf/ |
| A D | tea575x.h | 47 bool tuned; /* tuned to a station */ member
|
| /linux/Documentation/userspace-api/media/v4l/ |
| A D | vidioc-log-status.rst | 34 dealing with problems like no sound, no video and incorrectly tuned
|
| A D | ext-ctrls-fm-rx.rst | 60 If set, then the tuned programme carries traffic announcements.
|
| A D | ext-ctrls-fm-tx.rst | 85 If set, then the tuned programme carries traffic announcements.
|
| /linux/Documentation/devicetree/bindings/spi/ |
| A D | spi-rockchip.yaml | 70 (may need to be fine tuned for high capacitance lines).
|
| /linux/drivers/media/radio/ |
| A D | tea575x.c | 124 tea->tuned = tea->ops->get_pins(tea) & TEA575X_MOST ? 0 : 1; in snd_tea575x_read()
292 v->signal = tea->tuned ? 0xffff : 0; in snd_tea575x_g_tuner()
|
| /linux/Documentation/misc-devices/ |
| A D | apds990x.rst | 38 Platform data can provide tuned values to the conversion formulas if
|
| /linux/Documentation/scsi/ |
| A D | megaraid.rst | 77 as new controller classes get added, this will be tuned appropriately.
|
| /linux/arch/arm64/boot/dts/xilinx/ |
| A D | zynqmp-sck-kv-g-revB.dts | 103 &sdhci1 { /* on CC with tuned parameters */
|
| A D | zynqmp-sck-kv-g-revA.dts | 123 &sdhci1 { /* on CC with tuned parameters */
|
| /linux/drivers/devfreq/ |
| A D | Kconfig | 41 values that imply the usage rate. A device may provide tuned
|
| /linux/Documentation/admin-guide/media/ |
| A D | bt8xx.rst | 48 are in fact necessary may result in DVB devices that cannot be tuned due
|
| A D | si476x.rst | 136 0x12 readfreq Current tuned frequency
|
| /linux/Documentation/driver-api/media/drivers/ |
| A D | radiotrack.rst | 30 value, I wanted to see if the tuner could be tuned beyond the usual FM radio
|
| /linux/Documentation/ia64/ |
| A D | fsys.rst | 86 calls, it is possible to write a hand-tuned fsyscall_handler. For
87 example, fsys.S contains fsys_getpid(), which is a hand-tuned version
|
| /linux/drivers/media/dvb-frontends/ |
| A D | cx24116.c | 1408 goto tuned; in cx24116_set_frontend()
1420 tuned: /* Set/Reset B/W */ in cx24116_set_frontend()
|
| /linux/Documentation/networking/device_drivers/ethernet/intel/ |
| A D | e1000e.rst | 122 properly tuned for specific network traffic. Increasing this value adds extra
151 properly tuned for specific network traffic. If the system is reporting
|
| A D | e1000.rst | 214 properly tuned for specific network traffic. Increasing this value adds
281 efficiency if properly tuned for specific network traffic. If the
|
| A D | ixgb.rst | 144 efficiency if properly tuned for specific network traffic. Increasing
157 efficiency if properly tuned for specific network traffic. Increasing
|
| /linux/Documentation/virt/kvm/ |
| A D | halt-polling.rst | 120 be tuned on a per vm basis.
|
| /linux/Documentation/admin-guide/hw-vuln/ |
| A D | l1tf.rst | 481 Conditional L1D flushing is the default behaviour and can be tuned. See
504 Conditional L1D flushing is the default behaviour and can be tuned. See
537 SMT control and L1D flushing can be tuned by the command line
|
| /linux/arch/x86/math-emu/ |
| A D | README | 60 (2) Divide has been tuned to get reasonable performance. The algorithm
66 (3) The sqrt function has been tuned to get good performance. It is based
|
Completed in 27 milliseconds
12