Searched refs:g2_amp (Results 1 – 6 of 6) sorted by relevance
| /trusted-firmware-a/plat/marvell/armada/a8k/a80x0/board/ |
| A D | phy-porting-layer.h | 74 { .g1_amp = 0x8, .g2_amp = 0xa, .g3_amp = 0x1e,
99 { .g1_amp = 0x8, .g2_amp = 0xa, .g3_amp = 0x1e,
130 { .g1_amp = 0x8, .g2_amp = 0xa, .g3_amp = 0x1e,
155 { .g1_amp = 0x8, .g2_amp = 0xa, .g3_amp = 0x1e,
|
| /trusted-firmware-a/plat/marvell/armada/a8k/a70x0_mochabin/board/ |
| A D | phy-porting-layer.h | 44 { .g1_amp = 0x8, .g2_amp = 0xa, .g3_amp = 0x1e,
59 { .g1_amp = 0x8, .g2_amp = 0xa, .g3_amp = 0x1e,
|
| /trusted-firmware-a/drivers/marvell/comphy/ |
| A D | phy-default-porting-layer.h | 30 .g1_amp = 0x8, .g2_amp = 0xa, .g3_amp = 0x1e,
|
| A D | phy-comphy-cp110.h | 32 uint8_t g2_amp; member
|
| A D | phy-comphy-cp110.c | 601 data = sata_static_values->g2_amp << HPIPE_G2_SET_0_G2_TX_AMP_OFFSET; in mvebu_cp110_comphy_sata_power_on()
|
| /trusted-firmware-a/plat/marvell/octeontx/otx2/t91/t9130/board/ |
| A D | phy-porting-layer.h | 111 .g1_amp = 0x8, .g2_amp = 0xa,
|
Completed in 8 milliseconds