Searched refs:HS (Results 1 – 25 of 34) sorted by relevance
12
/u-boot/arch/x86/include/asm/arch-apollolake/acpi/ |
A D | lpss.asl | 15 /* LPIO1 HS-UART #1 */ 18 Name (_DDN, "Intel(R) HS-UART Controller #1") 21 /* LPIO1 HS-UART #2 */ 24 Name (_DDN, "Intel(R) HS-UART Controller #2") 27 /* LPIO1 HS-UART #3 */ 30 Name (_DDN, "Intel(R) HS-UART Controller #3") 33 /* LPIO1 HS-UART #4 */ 36 Name (_DDN, "Intel(R) HS-UART Controller #4")
|
/u-boot/doc/device-tree-bindings/usb/ |
A D | dwc2.txt | 1 Platform DesignWare HS OTG USB 2.0 controller 19 - "st,stm32f4x9-fsotg": The DWC2 USB FS/HS controller instance in STM32F4x9 SoCs 21 - "st,stm32f4x9-hsotg": The DWC2 USB HS controller instance in STM32F4x9 SoCs 22 configured in HS mode; 23 - "st,stm32f7-hsotg": The DWC2 USB HS controller instance in STM32F7 SoCs 24 configured in HS mode;
|
/u-boot/board/synopsys/hsdk/ |
A D | Kconfig | 18 bool "ARC HS Development Kit" 20 ARC HS Development Kit based on quard core ARC HS38 processor
|
A D | README | 2 Useful notes on bulding and using of U-Boot on ARC HS Development Kit (AKA HSDK) 7 The DesignWare ARC HS Development Kit is a ready-to-use platform for rapid
|
/u-boot/arch/arm/dts/ |
A D | omap4-u-boot.dtsi | 15 /* USB HS */
|
A D | omap3-beagle-xm-ab.dts | 12 /* HS USB Port 2 Power enable was inverted with the xM C */
|
A D | omap3-evm-common.dtsi | 16 /* HS USB Port 2 Power */ 27 /* HS USB Host PHY on PORT 2 */
|
A D | stih410-b2260.dts | 118 label = "HS-I2C2"; 125 label = "HS-I2C3";
|
A D | zynqmp-zcu100-revC.dts | 198 label = "HS-I2C2"; 204 label = "HS-I2C3"; 296 label = "HS-SPI1";
|
A D | omap5-u-boot.dtsi | 118 /* USB HS */
|
A D | omap3-igep0020-common.dtsi | 46 /* HS USB Port 1 Power */ 56 /* HS USB Host PHY on PORT 1 */
|
A D | rk3399-rock960.dts | 123 /* On High speed expansion (HS-SPI1) */
|
A D | omap3-beagle-xm.dts | 78 /* HS USB Port 2 Power */ 88 /* HS USB Host PHY on PORT 2 */
|
A D | omap3-beagle.dts | 52 /* HS USB Port 2 Power */ 62 /* HS USB Host PHY on PORT 2 */
|
A D | omap4-panda-common.dtsi | 84 /* HS USB Port 1 Power */ 102 /* HS USB Host PHY on PORT 1 */
|
A D | logicpd-som-lv.dtsi | 28 /* HS USB Host PHY on PORT 1 */
|
/u-boot/drivers/usb/cdns3/ |
A D | Kconfig | 18 This controller supports FF and HS mode. It doesn't support 39 This controller supports FF and HS mode. It doesn't support
|
/u-boot/doc/chromium/devkeys/ |
A D | kernel.keyblock | 4 …^�U��.f*a��A�T���&[w|��h����بO���塈z�Ř4�cU����K���Eڤ��zPj��o�����HS��u���6�mPH���-�-…
|
/u-boot/drivers/phy/ |
A D | Kconfig | 163 tristate "STMicroelectronics STM32 SoC USB HS PHY driver" 171 used by an HS USB Host controller, and the second one is shared 172 between an HS USB OTG controller and an HS USB Host controller,
|
/u-boot/doc/device-tree-bindings/phy/ |
A D | phy-stm32-usbphyc.txt | 1 STMicroelectronics STM32 USB HS PHY controller
|
/u-boot/doc/device-tree-bindings/fsp/fsp2/apollolake/ |
A D | fsp-s.txt | 460 - fsps,port-usb20-per-port-pe-txi-set: PerPort HS Pre-emphasis Bias 461 - fsps,port-usb20-per-port-txi-set: PerPort HS Transmitter Bias 462 - fsps,port-usb20-hs-skew-sel: Select the skew direction for HS transition 463 - fsps,port-usb20-i-usb-tx-emphasis-en: PerPort HS Transmitter Emphasis 464 - fsps,port-usb20-per-port-rxi-set: PerPort HS Receiver Bias 465 - fsps,port-usb20-hs-npre-drv-sel: Delay/skew's strength control for HS driver
|
/u-boot/arch/arm/mach-omap2/am33xx/ |
A D | Kconfig | 59 GP and HS EVM development platforms. The AM335x 239 GP and HS EVM development platforms.The AM437x
|
/u-boot/drivers/video/nexell/ |
A D | s5pxx18_dp_mipi.c | 270 int HS = sync->h_sync_width; in mipi_enable() local 354 HFP, HBP, HS, VFP, VBP, VS, 0); in mipi_enable()
|
/u-boot/arch/arc/ |
A D | Kconfig | 23 ISA for the Next Generation ARC-HS cores
|
/u-boot/drivers/usb/gadget/ |
A D | Kconfig | 83 bool "DesignWare USB2.0 HS OTG controller (gadget mode)" 94 bool "DesignWare USB2.0 HS OTG controller 8-bit PHY bus width"
|
Completed in 19 milliseconds
12