Home
last modified time | relevance | path

Searched refs:LVDS (Results 1 – 25 of 28) sorted by relevance

12

/u-boot/drivers/video/bridge/
A DKconfig7 requires LVDS, an eDP->LVDS bridge chip can be used to provide the
11 bool "Support Parade PS862X DP->LVDS bridge"
14 The Parade PS8622 and PS8625 are DisplayPort-to-LVDS (Low voltage
15 differential signalling) converters. They enable an LVDS LCD panel
17 LVDS capability, or where LVDS requires too many signals to route
21 bool "Support NXP PTN3460 DP->LVDS bridge"
24 The NXP PTN3460 is a DisplayPort-to-LVDS (Low voltage differential
25 signalling) converter. It enables an LVDS LCD panel to be connected
26 to an eDP output device such as an SoC that lacks LVDS capability,
27 or where LVDS requires too many signals to route on the PCB.
/u-boot/drivers/video/nexell/
A DKconfig11 bool "LVDS LCD"
13 Support for LVDS lcd output.
/u-boot/arch/arm/mach-rockchip/rk3368/
A DKconfig21 - MIPI-DSI/single-channel LVDS (muxed on the 'LVDS-A' pin-group)
39 with integrated CVBS (TP2825) / MIPI DSI / CSI / LVDS
/u-boot/drivers/video/rockchip/
A DKconfig17 (LVDS), embedded DisplayPort (eDP) and Display Serial Interface (DSI).
51 bool "LVDS Port"
54 This enables Low-voltage Differential Signaling(LVDS) display
/u-boot/doc/device-tree-bindings/video/
A Drockchip-lvds.txt1 Rockchip LVDS interface
17 serialized LVDS signal.
A Dintel-gma.txt14 - intel,panel-port-select : output port to use: 0=LVDS 1=DP_B 2=DP_C 3=DP_D
A Dtegra20-dc.txt35 - nvidia,lvds-shutdown-gpios: LVDS power shutdown GPIO
/u-boot/arch/arm/mach-rockchip/rk3128/
A DKconfig12 usb2.0 host ports, LVDS, JTAG, MAC, SDcard, HDMI, USB-2-serial...
/u-boot/board/advantech/
A DKconfig20 HDMI/DisplayPort/DVI, LVDS, VGA
/u-boot/board/boundary/nitrogen6x/
A DREADME52 Hannstar-XGA - 1024 x 768 LVDS (Freescale part number MCIMX-LVDS1)
53 wsvga-lvds - 1024 x 600 LVDS (Boundary p/n Nit6X_1024x600)
58 or the I2C touch controller of the LVDS and RGB displays in the priority
/u-boot/arch/arm/dts/
A Dimx6dl-aristainetos2_7.dtsi4 * parts for 7 inch LG display connected to the LVDS port
A Ds5p4418-nanopi2.dts60 /* NanoPi2: LCD interface, NanoPC-T2: LCD, LVDS and MIPI interfaces */
A Dexynos5420-peach-pit.dts142 * [7:4] LVDS driver bias current :
201 * Set LVDS output as 6bit-VESA mapping,
202 * single LVDS channel
A Dexynos5250-spring.dts623 /* [7:4] LVDS driver bias current 75% (250mV swing) */
669 * Set LVDS output as 6bit-VESA mapping, single LVDS
A Dimx53-m53menlo.dts245 /* LVDS pins only have pin mux configuration */
A Dr8a77995-draak.dts280 /* Depends on LVDS */
/u-boot/arch/arm/mach-rockchip/rk3328/
A DKconfig11 usb2.0 host ports, LVDS, JTAG, MAC, SDcard, HDMI, USB-2-serial...
/u-boot/include/
A Dlattice.h205 #define LVDS 0x71 /* Support LVDS. */ macro
/u-boot/doc/board/amlogic/
A Dindex.rst67 | LCD/LVDS Output | No | *N/A* | No | No | No …
/u-boot/board/intel/
A DKconfig43 peripheral connectors for PCIe/SATA/USB/LAN/SD/UART/Audio/LVDS.
/u-boot/drivers/fpga/
A Divm_core.c512 case LVDS: in ispVMMemManager()
1046 case LVDS: in ispVMCode()
3107 ispVMMemManager(LVDS, a_usLVDSCount); in ispVMProcessLVDS()
/u-boot/arch/arm/mach-rockchip/rk3399/
A DKconfig22 USB.0 host ports, LVDS, JTAG, MAC, SD card, HDMI, USB-to-serial...
/u-boot/doc/board/kontron/
A Dsl28.rst89 10 Keep eDP-to-LVDS converter in reset
/u-boot/drivers/video/tegra124/
A Dsor.c569 DUMP_REG(LVDS); in dump_sor_reg()
844 tegra_sor_writel(sor, LVDS, 0); in tegra_dc_sor_set_lane_parm()
/u-boot/drivers/video/
A DKconfig472 bool "Hitachi tx18d42vm LVDS LCD panel support"
476 Support for Hitachi tx18d42vm LVDS LCD panels, these panels have a
478 done they work like a regular LVDS panel.
588 a VESA device and supports LCD panels, eDP and LVDS outputs.
600 a VESA device and supports LCD panels, eDP and LVDS outputs.

Completed in 21 milliseconds

12