Searched refs:analog (Results 1 – 25 of 26) sorted by relevance
12
/u-boot/drivers/phy/ |
A D | meson-axg-mipi-dphy.c | 181 struct phy analog; member 196 ret = generic_phy_configure(&priv->analog, config); in phy_meson_axg_mipi_dphy_configure() 212 ret = generic_phy_power_on(&priv->analog); in phy_meson_axg_mipi_dphy_power_on() 297 return generic_phy_power_off(&priv->analog); in phy_meson_axg_mipi_dphy_power_off() 306 ret = generic_phy_init(&priv->analog); in phy_meson_axg_mipi_dphy_init() 325 ret = generic_phy_exit(&priv->analog); in phy_meson_axg_mipi_dphy_exit() 349 ret = generic_phy_get_by_index(dev, 0, &priv->analog); in meson_axg_mipi_dphy_probe()
|
A D | Makefile | 26 obj-$(CONFIG_MESON_AXG_MIPI_PCIE_ANALOG_PHY) += meson-axg-mipi-pcie-analog.o
|
/u-boot/drivers/adc/ |
A D | Kconfig | 19 - 10 analog input channels 28 - 4 analog input channels 38 - 8 analog input channels 47 - 2~6 analog input channels 55 This enables driver for STMicroelectronics STM32 analog-to-digital
|
/u-boot/doc/device-tree-bindings/thermal/ |
A D | ti_soc_thermal.txt | 7 circuits and other analog IP blocks. The analog-to-digital
|
/u-boot/doc/device-tree-bindings/adc/ |
A D | st,stm32-adc.txt | 3 STM32 ADC is a successive approximation analog-to-digital converter. 9 The analog watchdog feature allows the application to detect if the input 33 - "adc" clock: for the analog circuitry, common to all ADCs. 41 - vref-supply: Phandle to the vref input analog reference voltage. 48 inX ADC pins in mode of operation for analog input on external pin. 91 Depending on hardware (board) e.g. high/low analog input source impedance,
|
/u-boot/doc/imx/common/ |
A D | imx5.txt | 13 condition in an analog flip-flop when used at high frequencies.
|
/u-boot/arch/arm/mach-tegra/tegra210/ |
A D | Kconfig | 21 a GPIO expansion header, and an analog audio jack.
|
/u-boot/doc/device-tree-bindings/phy/ |
A D | phy-mtk-tphy.txt | 51 "da_ref": the reference clock of analog phy, used if the clocks 52 of analog and digital phys are separated, otherwise uses
|
/u-boot/arch/arm/dts/ |
A D | omap3-evm-common.dtsi | 89 * TVP5146 Video decoder-in for analog input support.
|
A D | sun8i-a23.dtsi | 63 allwinner,codec-analog-controls = <&codec_analog>;
|
A D | imx6q-cm-fx6.dts | 100 sound-analog { 102 simple-audio-card,name = "On-board analog audio";
|
A D | meson-gx-p23x-q20x.dtsi | 19 dio2133: analog-amplifier {
|
A D | tegra30-apalis.dts | 186 * only required for analog RGB
|
A D | sunxi-h3-h5.dtsi | 663 allwinner,codec-analog-controls = <&codec_analog>; 847 codec_analog: codec-analog@1f015c0 { 848 compatible = "allwinner,sun8i-h3-codec-analog";
|
A D | meson-gxl-s905x-libretech-cc.dts | 25 dio2133: analog-amplifier {
|
A D | meson-gx-libretech-pc.dtsi | 33 dio2133: analog-amplifier {
|
A D | sun8i-a23-a33.dtsi | 606 codec_analog: codec-analog { 607 compatible = "allwinner,sun8i-a23-codec-analog";
|
A D | bcm283x.dtsi | 145 * pixel clocks come from the DSI analog PHY.
|
A D | sun50i-a64.dtsi | 1217 codec_analog: codec-analog@1f015c0 { 1218 compatible = "allwinner,sun50i-a64-codec-analog";
|
A D | am43x-epos-evm.dts | 548 * High: LCD display with analog audio via aic3111 codec
|
A D | rk3328.dtsi | 162 analog_sound: analog-sound {
|
/u-boot/arch/mips/dts/ |
A D | mt7628a.dtsi | 138 function = "analog";
|
/u-boot/doc/device-tree-bindings/pinctrl/ |
A D | st,stm32-pinctrl.txt | 166 /* GPIO A9 set as analog */
|
/u-boot/board/freescale/ls1028a/ |
A D | README | 159 - Include stereo LINEIN with support for external analog input
|
/u-boot/drivers/spi/ |
A D | Kconfig | 12 chips, analog to digital (and d-to-a) converters, and more.
|
Completed in 39 milliseconds
12