Searched refs:backup (Results 1 – 25 of 34) sorted by relevance
12
| /u-boot/arch/x86/lib/ |
| A D | ramtest.c | 52 u32 backup; in quick_ram_check() local
54 backup = read_phys(CONFIG_RAMBASE); in quick_ram_check()
72 write_phys(CONFIG_RAMBASE, backup); in quick_ram_check()
|
| /u-boot/configs/ |
| A D | CHIP_pro_defconfig | 12 CONFIG_MTDPARTS_DEFAULT="mtdparts=sunxi-nand.0:256k(spl),256k(spl-backup),2m(uboot),2m(uboot-backup…
|
| A D | am65x_hs_evm_a53_defconfig | 64 …spi.tiboot3),2m(ospi.tispl),4m(ospi.u-boot),128k(ospi.env),128k(ospi.env.backup),1m(ospi.sysfw),-@…
|
| A D | am65x_evm_a53_defconfig | 68 …spi.tiboot3),2m(ospi.tispl),4m(ospi.u-boot),128k(ospi.env),128k(ospi.env.backup),1m(ospi.sysfw),-@…
|
| A D | j721e_hs_evm_a72_defconfig | 65 …spi.tiboot3),2m(ospi.tispl),4m(ospi.u-boot),128k(ospi.env),128k(ospi.env.backup),1m(ospi.sysfw),-@…
|
| A D | j7200_evm_a72_defconfig | 75 …spi.tiboot3),2m(ospi.tispl),4m(ospi.u-boot),128k(ospi.env),128k(ospi.env.backup),1m(ospi.sysfw),-@…
|
| A D | j721e_evm_a72_defconfig | 72 …spi.tiboot3),2m(ospi.tispl),4m(ospi.u-boot),128k(ospi.env),128k(ospi.env.backup),1m(ospi.sysfw),-@…
|
| /u-boot/doc/ |
| A D | README.bcmns3 | 5 different images like fip.bin, nitro firmware, DDR shmo value and other backup
|
| A D | README.gpt | 219 employing 'swap' to exchange 'primary' and 'backup' partition names:
221 U-BOOT> gpt swap mmc 0 primary backup
224 'backup', and vice-versa. Alternatively, single partitions may be
|
| A D | README.marvell | 64 Prior flashing new U-Boot version (as part of ATF image) it is suggested to backup
|
| A D | README.chromium-chainload | 211 Used to make a backup of your firmware, or to replace it.
|
| /u-boot/board/sbc8641d/ |
| A D | README | 33 booting, or for U-Boot backup and recovery. A two pin jumper on the
|
| /u-boot/board/sunxi/ |
| A D | README.nand | 46 Then write the SPL and its backup:
|
| /u-boot/board/ti/am65x/ |
| A D | README | 254 | backup environment (128 KB) | | |
300 | ospi.env.backup (128K) |
|
| /u-boot/arch/arm/dts/ |
| A D | am437x-idk-evm.dts | 361 label = "QSPI.U_BOOT.backup";
373 label = "QSPI.U-BOOT-ENV.backup";
|
| A D | omap5-board-common.dtsi | 420 ti,backup-battery-chargeable;
421 ti,backup-battery-charge-high-current;
|
| A D | am437x-sk-evm.dts | 590 label = "QSPI.U_BOOT.backup";
602 label = "QSPI.U-BOOT-ENV.backup";
|
| A D | ulcb.dtsi | 271 rohm,ddr-backup-power = <0xf>;
|
| A D | am43x-epos-evm.dts | 722 label = "QSPI.U_BOOT.backup";
734 label = "QSPI.U-BOOT-ENV.backup";
|
| A D | r8a77990-ebisu.dts | 474 rohm,ddr-backup-power = <0x1>;
|
| /u-boot/doc/build/ |
| A D | gcc.rst | 133 * mrproper - remove all generated files + config + various backup files
|
| /u-boot/doc/device-tree-bindings/clock/ |
| A D | st,stm32h7-rcc.txt | 25 - st,syscfg: phandle for pwrcfg, mandatory to disable/enable backup domain
|
| /u-boot/board/ti/j721e/ |
| A D | README | 264 | ospi.env.backup (128K) |
|
| /u-boot/env/ |
| A D | Kconfig | 151 a valid backup copy in case there is a power failure during
201 valid backup copy in case the other copy is corrupted, e.g. due
228 that there is a valid backup copy in case there is a power failure
323 that there is a valid backup copy in case there is a power failure
417 copy of the environment data, so that there is a valid backup copy in
|
| /u-boot/drivers/rtc/ |
| A D | Kconfig | 48 has a selectable I2C-bus or SPI-bus, a backup battery switch-over circuit, a
|
Completed in 23 milliseconds
12