Searched refs:difference (Results 1 – 25 of 32) sorted by relevance
12
| /u-boot/fs/yaffs2/ |
| A D | yaffs_verify.c | 502 int difference; in yaffs_verify_free_chunks() local
509 difference = dev->n_free_chunks - counted; in yaffs_verify_free_chunks()
511 if (difference) { in yaffs_verify_free_chunks()
514 dev->n_free_chunks, counted, difference); in yaffs_verify_free_chunks()
|
| /u-boot/arch/arm/dts/ |
| A D | armada-388.dtsi | 9 * The main difference with the Armada 385 is that the 388 can handle two more
|
| A D | sun4i-a10-pcduino2.dts | 45 * LinkSprite pcDuino1 board. The only software visible difference
|
| /u-boot/board/congatec/conga-qeval20-qa3-e3845/ |
| A D | README | 6 configurations (defconfig files). The only difference is the UART that
|
| /u-boot/arch/arm/cpu/armv8/fsl-layerscape/doc/ |
| A D | README.soc | 256 1)LS2048A, few difference w.r.t. LS2088A:
259 2)LS2084A, few difference w.r.t. LS2088A:
265 3)LS2044A, few difference w.r.t. LS2084A:
275 1)LS2041A, few difference w.r.t. LS2081A:
328 1)LX2120A, few difference w.r.t. LX2160A:
331 2)LX2080A, few difference w.r.t. LX2160A:
433 1)LX2122A, few difference w.r.t. LX2162A:
436 2)LX2082A, few difference w.r.t. LX2162A:
|
| A D | README.qspi | 17 The difference between QSPI boot RCW image and NOR boot image is the PBI
|
| A D | README.lsch3 | 156 The difference between NAND boot RCW image and NOR boot image is the PBI
201 Notice the difference from QDS is SRC, SRC_ADDR and the offset of u-boot image
209 The difference between SD boot RCW image and QSPI-NOR boot image is the
|
| /u-boot/doc/ |
| A D | README.fsl_iim | 38 immediately, but this does not make any difference for a user reading
|
| A D | README.ramboot-ppc85xx | 41 The main difference among all of them is the way the pre-environment is getting
73 The main difference between the above two methods from technical perspective is
|
| A D | README.dfutftp | 96 (./doc/README.update) with one notable difference:
|
| A D | README.generic-board | 125 just the difference between __bss_end and __bss_end__.
|
| A D | README.pxe | 224 The biggest difference between U-Boot's pxe and PXELINUX is that since
|
| A D | README.ti-secure | 165 The only difference is the key is not checked on non-secure devices so
|
| A D | README.nand | 169 the difference between a U-Boot driver and its Linux counterpart.
|
| /u-boot/arch/arm/mach-stm32mp/ |
| A D | Kconfig | 78 The difference between board are managed with devicetree
|
| /u-boot/doc/device-tree-bindings/net/ |
| A D | mdio-mux.txt | 3 One notable difference to Linux is that mdio-parent-bus is currently required
|
| /u-boot/doc/uImage.FIT/ |
| A D | command_syntax_extensions.txt | 106 Ad. 13. Similar to case 12, the difference being that <addr3> is the address
115 Ad. 15. Similar to case 14, the difference being that <addr3> is the address
|
| /u-boot/drivers/mtd/ubi/ |
| A D | Kconfig | 28 This parameter defines the maximum difference between the highest
|
| /u-boot/doc/imx/clk/ |
| A D | ccf.txt | 15 difference is the lack of support for hierarchical clocks and "clock as a
|
| /u-boot/board/synopsys/iot_devkit/ |
| A D | README | 69 Data Closely Coupled Memory is similar to ICCM with a major difference -
|
| /u-boot/board/sbc8349/ |
| A D | README | 14 difference in the two is the level of PCI functionality.
|
| /u-boot/doc/imx/mkimage/ |
| A D | mxsimage.txt | 83 one difference. The CALL instruction does allow returning into the
|
| /u-boot/board/freescale/mx6qarm2/ |
| A D | imximage_mx6dl.cfg | 160 /* values of 20,40,50,60,7f tried. no difference seen */
|
| /u-boot/board/freescale/t104xrdb/ |
| A D | README | 26 Basic difference's among T1040RDB, T1042RDB_PI, T1042RDB
|
| /u-boot/doc/develop/ |
| A D | trace.rst | 315 2. Build U-Boot with tracing and run it. Note the difference in boot time
|
Completed in 16 milliseconds
12