Searched refs:hard (Results 1 – 25 of 38) sorted by relevance
12
| /u-boot/doc/ |
| A D | README.sata | 3 There are two ways to operate the hard disk
5 * Read/write raw blocks from/to SATA hard disk
8 1.0 How to read the SATA hard disk's information?
17 1.1 How to raw write the kernel, file system, dtb to a SATA hard disk?
34 1.2 How to raw read the kernel, file system, dtb from a SATA hard disk?
|
| A D | README.nvme | 45 To use an NVMe hard disk from U-Boot shell, a 'nvme scan' command needs to
46 be executed for all NVMe hard disks attached to the NVMe controller to be
49 To list all of the NVMe hard disks, try:
67 Of course, file system command can be used on the NVMe hard disk as well:
|
| A D | README.esbc_validate | 27 5. In case of hard failure, SoC is issued RESET REQUEST after
|
| A D | README.i2c | 9 transaction it is hard to know the state of the bus.
|
| A D | README.falcon | 96 rather than the hard-coded value.
98 mode rather than the hard-coded value.
|
| A D | README.unaligned-memory-access.txt | 63 resulting in a subtle code bug that is hard to detect!
73 At first, the concepts above may seem a little hard to relate to actual
|
| A D | README.generic-board | 98 #ifdefs to select fields for a particular SOC, so it is hard to
|
| A D | README.chromium-chainload | 228 beforehand. It can be quite hard to figure out between these two code bases
|
| /u-boot/fs/jffs2/ |
| A D | Kconfig | 7 hard links and compression.
|
| /u-boot/arch/arm/dts/ |
| A D | dra76x.dtsi | 16 /* MCAN interrupts are hard-wired to irqs 67, 68 */
|
| /u-boot/drivers/scsi/ |
| A D | Kconfig | 7 hard drives and optical drives. The SCSI standards define physical
|
| /u-boot/arch/arm/include/asm/ |
| A D | processor.h | 31 struct fp_hard_struct hard; member
|
| /u-boot/drivers/ata/ |
| A D | Kconfig | 15 Attachment), a serial bus standard for connecting to hard drives and
48 This option enables Ceva Sata controller hard IP available on Xilinx
|
| /u-boot/arch/mips/cpu/ |
| A D | start.S | 41 li a0, 0 # Use hard register context
|
| /u-boot/drivers/block/ |
| A D | Kconfig | 70 Enables support for IDE (Integrated Drive Electronics) hard drives.
|
| /u-boot/doc/arch/ |
| A D | nds32.rst | 44 N1213 is a configurable hard/soft core of NDS32's N12 CPU family.
|
| A D | x86.rst | 356 You can also bake this behaviour into your build by hard-coding the
416 # Create a 10G disk.img as the virtual hard disk
422 # Boot a Windows XP OS installed on the virutal hard disk
|
| /u-boot/board/freescale/p2041rdb/ |
| A D | README | 111 cpld reset - hard reset to default bank
|
| /u-boot/arch/arm/mach-zynqmp/ |
| A D | Kconfig | 83 Leave this option empty if your PMU firmware has a hard-coded
|
| /u-boot/doc/board/emulation/ |
| A D | qemu-x86.rst | 77 from hard disk or network again, through emulated devices. To use it , simply
|
| /u-boot/doc/board/intel/ |
| A D | slimbootloader.rst | 95 1. Prepare Yocto hard disk image::
|
| /u-boot/board/buffalo/lsxl/ |
| A D | README | 9 are loaded from the hard disk.
|
| /u-boot/examples/standalone/ |
| A D | README.smc91111_eeprom | 84 The Load point is a hard coded address from the
|
| /u-boot/board/sbc8548/ |
| A D | README | 68 The default configuration uses hard coded memory configuration settings
|
| /u-boot/doc/board/google/ |
| A D | chromebook_coral.rst | 44 at hard-coded addresses in the memory map. PCI auto-config is not used.
|
Completed in 20 milliseconds
12