Searched refs:inputs (Results 1 – 21 of 21) sorted by relevance
| /u-boot/doc/ |
| A D | README.VSC3316-3308 | 14 On reset, VSC devices are in low-power state with all inputs, outputs and connections in an off sta…
30 …for required connections. Connection through the VSC device requires the inputs and outputs to be …
|
| /u-boot/arch/mips/dts/ |
| A D | jr2_pcb110.dts | 54 /* SPIO only use DO, CLK, no inputs */
|
| A D | jr2_pcb111.dts | 54 /* SPIO only use DO, CLK, no inputs */
|
| /u-boot/arch/arm/dts/ |
| A D | r8a77995-draak.dts | 259 * CVBS and HDMI inputs through SW[49-53]
332 * CVBS and HDMI inputs through SW[49-53]
|
| A D | sun8i-q8-common.dtsi | 57 * short-circuits we configure these as inputs with pull-ups via
|
| A D | stih410-clock.dtsi | 8 * Fixed 30MHz oscillator inputs to SoC
|
| A D | stih407-clock.dtsi | 8 * Fixed 30MHz oscillator inputs to SoC
|
| A D | k3-am65-mcu.dtsi | 257 ti,cpts-ext-ts-inputs = <4>;
|
| A D | k3-j7200-mcu-wakeup.dtsi | 209 ti,cpts-ext-ts-inputs = <4>;
|
| A D | tegra30-cardhu.dts | 33 /* AVDD_PEXA and VDD_PEXA inputs are grounded on Cardhu. */
|
| A D | k3-j721e-mcu-wakeup.dtsi | 370 ti,cpts-ext-ts-inputs = <4>;
|
| A D | omap4-panda-common.dtsi | 351 /* wl12xx GPIO inputs and SDIO pins */
|
| A D | omap4-sdp.dts | 334 /* wl12xx GPIO inputs and SDIO pins */
|
| A D | k3-j7200-main.dtsi | 277 ti,cpts-ext-ts-inputs = <8>;
|
| A D | k3-am65-main.dtsi | 656 ti,cpts-ext-ts-inputs = <8>;
|
| A D | k3-j721e-main.dtsi | 337 ti,cpts-ext-ts-inputs = <8>;
|
| /u-boot/doc/device-tree-bindings/adc/ |
| A D | st,stm32-adc.txt | 72 inputs pairs as <vinp vinn>, <vinp vinn>,... vinp and vinn are numbered
130 - channels 2 & 3 as differential (with resp. 6 & 7 negative inputs)
|
| /u-boot/arch/powerpc/cpu/mpc83xx/ |
| A D | Kconfig | 171 * Several display port inputs and outputs, and supporting redrivers
|
| /u-boot/drivers/sound/ |
| A D | Kconfig | 131 an I2C interface and supports multiple sound inputs and outputs,
|
| /u-boot/ |
| A D | Makefile | 1042 PHONY += inputs
1043 inputs: $(INPUTS-y) target
1045 all: .binman_stamp inputs
|
| /u-boot/doc/device-tree-bindings/gpio/ |
| A D | gpio.txt | 91 GPIO controller that achieves (or represents, for inputs) a logically asserted
|
Completed in 38 milliseconds