Searched refs:log_info (Results 1 – 19 of 19) sorted by relevance
| /u-boot/arch/x86/cpu/broadwell/ |
| A D | adsp.c | 96 log_info("ADSP: Enable ACPI Mode IRQ3\n"); in broadwell_adsp_probe()
111 log_info("ADSP: Enable PCI Mode IRQ23\n"); in broadwell_adsp_probe()
|
| /u-boot/lib/efi_loader/ |
| A D | efi_bootmgr.c | 128 log_info("Booting: %ls\n", lo.label); in try_load_entry()
206 log_info("BootOrder not defined\n"); in efi_bootmgr_load()
|
| A D | efi_disk.c | 567 log_info("Scanning disk %s...\n", dev->name); in efi_disk_register()
599 log_info("Scanning disks on %s...\n", if_typename); in efi_disk_register()
634 log_info("Found %d disks\n", disks); in efi_disk_register()
|
| /u-boot/include/linux/ |
| A D | printk.h | 62 CONFIG_LOGLEVEL > 6 ? log_info(fmt, ##__VA_ARGS__) : 0; \
|
| /u-boot/common/ |
| A D | malloc_simple.c | 81 log_info("malloc_simple: %lx bytes used, %lx remain\n", gd->malloc_ptr, in malloc_simple_info()
|
| /u-boot/arch/arm/mach-stm32mp/ |
| A D | spl.c | 86 log_info("Model: %s\n", model); in spl_display_print()
|
| /u-boot/include/ |
| A D | log.h | 165 #define log_info(_fmt...) log(LOG_CATEGORY, LOGL_INFO, ##_fmt) macro
178 #define log_info(_fmt, ...) printf(_fmt, ##__VA_ARGS__) macro
|
| /u-boot/board/st/common/ |
| A D | stpmic1.c | 208 log_info("Keep debug unit ON\n"); in stpmic1_init()
|
| /u-boot/test/log/ |
| A D | syslog_test.c | 197 log_info("testing %s\n", "log_info"); in log_test_syslog_info()
|
| A D | log_test.c | 274 log_info("level %d\n", LOGL_INFO); in do_log_test_helpers()
|
| /u-boot/drivers/power/acpi_pmc/ |
| A D | acpi-pmc-uclass.c | 65 log_info("PMC: Using default GPE route"); in pmc_gpe_init()
|
| /u-boot/board/st/stm32mp1/ |
| A D | stm32mp1.c | 116 log_info("Board: stm32mp1 in %s mode (%s)\n", mode, in checkboard()
128 log_info("Board: MB%04x Var%d.%d Rev.%c-%02d\n", in checkboard()
|
| /u-boot/drivers/misc/ |
| A D | cros_ec.c | 1006 log_info("EFS: EC is verifying updated image...\n"); in cros_ec_efs_verify()
1011 log_info("EFS: Verification success\n"); in cros_ec_efs_verify()
1015 log_info("EFS: EC doesn't support EFS_VERIFY command\n"); in cros_ec_efs_verify()
1018 log_info("EFS: Verification failed\n"); in cros_ec_efs_verify()
|
| /u-boot/drivers/clk/ |
| A D | clk_stm32mp1.c | 2290 log_info("Clocks:\n"); in stm32mp1_clk_probe()
2291 log_info("- MPU : %s MHz\n", strmhz(buf, gd->cpu_clk)); in stm32mp1_clk_probe()
2292 log_info("- MCU : %s MHz\n", in stm32mp1_clk_probe()
2294 log_info("- AXI : %s MHz\n", strmhz(buf, gd->bus_clk)); in stm32mp1_clk_probe()
2295 log_info("- PER : %s MHz\n", in stm32mp1_clk_probe()
2297 log_info("- DDR : %s MHz\n", strmhz(buf, gd->mem_clk)); in stm32mp1_clk_probe()
|
| /u-boot/arch/sandbox/cpu/ |
| A D | start.c | 492 log_info("sandbox: starting...\n"); in main()
|
| /u-boot/cmd/ |
| A D | bootefi.c | 476 log_info("Booting %pD\n", msg_path); in efi_run_image()
|
| /u-boot/lib/ |
| A D | tpm-v1.c | 76 log_info("TPM: Clear and re-enable\n"); in tpm_clear_and_reenable()
|
| /u-boot/doc/develop/ |
| A D | logging.rst | 118 * log_info(_fmt...)
|
| /u-boot/arch/x86/lib/ |
| A D | acpi_table.c | 761 log_info("Device not enabled\n"); in acpi_write_dbg2_pci_uart()
|
Completed in 35 milliseconds