Searched refs:programmed (Results 1 – 25 of 38) sorted by relevance
12
38 unsigned programmed = 0; in pmic_init() local120 programmed++; in pmic_init()124 return programmed; in pmic_init()127 programmed++; in pmic_init()131 return programmed; in pmic_init()134 programmed++; in pmic_init()136 switch (programmed) { in pmic_init()149 if (programmed != 3) { in pmic_init()154 return programmed; in pmic_init()213 return programmed; in pmic_init()
38 unsigned programmed = 0; in pmic_init() local120 programmed++; in pmic_init()124 return programmed; in pmic_init()127 programmed++; in pmic_init()131 return programmed; in pmic_init()134 programmed++; in pmic_init()136 switch (programmed) { in pmic_init()198 return programmed; in pmic_init()
6 A fuse corresponds to a single non-volatile memory bit that can be programmed8 fuse that has not been programmed reads 0.45 Only the bits to be programmed should be set in the input value (i.e. for46 fuse bits that have already been programmed and hence should be left61 fuses have already been programmed or are locked (if the SoC allows to
10 routed to the Wolfson WM8776 codec. The ngPIXIS can be programmed to13 will be programmed accordingly. Second, the clock-frequency property
6 The SPEAr SoC family embeds a customizable logic that can be programmed73 environment variables. Although, we can check the mac id programmed in i2c
14 we also don't do. The BATs are programmed just for the benefit of
53 This image should be programmed at offset 0 in the NAND flash:
44 from NOR flash. The resulting image file can be programmed to the SPI flash
47 Previous behavior had the MAC address always being programmed into hardware
21 The OMAP-L138 and AM1808 SoM are programmed with28 The DA850 EVM comes with SoM are programmed with
12 boot-flash. Stage1 bootloader inturns locates and jumps to U-Boot programmed
23 default u-boot.rom image for this board is set to 2MB, it should be programmed
24 * The EFUSE_SMA register is not programmed for any of the AM335x wafers
154 read-only; /* Manufacturing EEPROM programmed at factory */
188 read-only; /* Manufacturing EEPROM programmed at factory */
183 read-only; /* Manufacturing EEPROM programmed at factory */
9 information from an EEPROM on the board programmed at the factory and supports47 settings programmed at the factory.68 The Gateworks Ventana boards with NAND flash have been factory programmed83 header must be programmed in the NAND flash boot device at an offset hard85 The image can be programmed from either U-Boot or Linux:110 When the IMX6 eFUSE settings have been factory programmed to boot from
21 SPL image that is ready to be programmed directly embedding the ECCs,
33 binary and the SRK Hash is programmed in the SoC fuses for establishing the60 The U-Boot image to be programmed into the boot media needs to be properly235 SRK Hash is programmed in the SoC SRK_HASH[255:0] fuses.
140 fuse values are generated by the srktool and should be programmed in the223 Once the fuse is programmed, the chip does not load an image that has not been246 Additional fuses can be programmed for completely secure the device, more
29 The SPL portion is programmed into a certain location for use by the internal
19 programmed. Channel 4 (the last) is normally used as a timer.
342 Assumption: MC firmware, DPL and DPC dtb is already programmed356 Assumption: MC firmware, DPL and DPC dtb is already programmed375 programmed on NOR flash.
179 flash-programmed over a USB connection. On dev boards, this is
73 has been programmed into the first two 64 KB sectors of the Flash.
Completed in 23 milliseconds