Searched refs:reliable (Results 1 – 12 of 12) sorted by relevance
81 int reliable; in rtc_post_test() local84 reliable = rtc_get (&svtm); in rtc_post_test()183 if (reliable < 0) { in rtc_post_test()
15 work reliable. So here this command should be used:
179 * TX clock internal delay mode is required for reliable183 * 100Mbps for reliable communication.
273 * TX clock internal delay mode is required for reliable277 * 100Mbps for reliable communication.
89 * The gsl1680 is rated at 400KHz and it will not work reliable at
66 * The gsl1680 is rated at 400KHz and it will not work reliable at
9 of reset (if any). The only reliable solution for setting up line direction is
305 Torture block to determine if it is still reliable.307 This command returns 0 if the block is still reliable, else 1.324 command returns 0 if all tested blocks have been found reliable, else 1.
542 autodetection are not very reliable and depend on the chip
1277 there is no other option. The Ymodem protocol provides a reliable1604 there is no other option. The Ymodem protocol provides a reliable
535 The reliable source is the hardware as sometimes chipset datasheet is not 100%
2488 The two-step approach is usually more reliable, since
Completed in 25 milliseconds