| /u-boot/doc/device-tree-bindings/net/ |
| A D | mdio-mux-reg.txt | 7 selection. mux-reg-mask property described below must
10 Register bits enabled in mask are set to the selection
12 selection.
|
| /u-boot/lib/efi_loader/ |
| A D | efi_tcg2.c | 370 static bool is_active_pcr(struct tpms_pcr_selection *selection) in is_active_pcr() argument
377 for (i = 0; i < selection->size_of_select; i++) { in is_active_pcr()
378 if (selection->pcr_select[i]) in is_active_pcr()
430 u32 hash_offset = offsetof(struct tpml_pcr_selection, selection) + in tpm2_get_pcr_info()
440 pcrs.selection[i].hash = in tpm2_get_pcr_info()
442 pcrs.selection[i].size_of_select = in tpm2_get_pcr_info()
444 if (pcrs.selection[i].size_of_select > TPM2_PCR_SELECT_MAX) in tpm2_get_pcr_info()
448 pcrs.selection[i].size_of_select); in tpm2_get_pcr_info()
452 u32 hash_mask = alg_to_mask(pcrs.selection[i].hash); in tpm2_get_pcr_info()
456 if (is_active_pcr(&pcrs.selection[i])) in tpm2_get_pcr_info()
[all …]
|
| /u-boot/board/cortina/common/ |
| A D | Kconfig | 6 to enables selection of CAxxxx drivers
|
| /u-boot/board/kobol/helios4/ |
| A D | README | 20 Boot selection:
23 Before powering up the board, boot selection should be done via the SW1 dip
|
| /u-boot/board/samsung/common/ |
| A D | misc.c | 336 char *selection[BOOT_MODE_EXIT + 1]; in display_download_menu() local
340 selection[i] = "[ ]"; in display_download_menu()
342 selection[mode] = "[=>]"; in display_download_menu()
348 lcd_printf("\t%s %s - %s\n\n", selection[i], in display_download_menu()
|
| /u-boot/board/Arcturus/ucp1020/ |
| A D | README | 11 - the selection of populated phy(s):
14 - the selection of boot location:
|
| /u-boot/arch/arm/mach-u8500/ |
| A D | Kconfig | 7 prompt "U8500 board selection"
|
| /u-boot/board/solidrun/clearfog/ |
| A D | README | 43 Boot selection:
46 Before powering up the board, boot selection should be done via the SW1 dip
|
| /u-boot/doc/ |
| A D | README.multi-dtb-fit | 16 The selection is done using board_fit_config_name_match() (same as what the SPL
17 uses to select the DTB for U-Boot). The selection happens during fdtdec_setup()
38 Uncompression and selection stages happen in fdtdec_setup() which is called
|
| /u-boot/doc/device-tree-bindings/video/ |
| A D | syncoam,seps525.txt | 3 Driver for seps525 display controller (in spi mode), This binding supports selection
|
| A D | intel-gma.txt | 4 This is the Intel Graphics Media Accelerator. This binding supports selection
|
| /u-boot/arch/arm/dts/ |
| A D | ast2600-u-boot.dtsi | 14 uart-clk-source = <0x0>; /* uart clock source selection: 0: uxclk 1: huxclk*/
|
| /u-boot/board/congatec/conga-qeval20-qa3-e3845/ |
| A D | README | 2 U-Boot console UART selection:
|
| /u-boot/doc/uImage.FIT/ |
| A D | overlay-fdt-boot.txt | 203 Configuration using overlays and feature selection
208 hand in the FIT image. For the add-on boards the extra config selection method
220 The limitation for a feature selection configuration node is that a single
|
| /u-boot/doc/device-tree-bindings/pinctrl/ |
| A D | st,stm32-pinctrl.txt | 41 -The phandle to the syscon node which includes IRQ mux selection register.
42 -The offset of the IRQ mux selection register
57 - st,bank-ioport: should correspond to the EXTI IOport selection (EXTI line
|
| /u-boot/doc/usage/ |
| A D | bootmenu.rst | 11 selected using the "Enter" key. The selection of the highlighted
17 selection.
|
| /u-boot/doc/device-tree-bindings/misc/ |
| A D | intel,baytrail-fsp.txt | 63 - fsp,os-selection
130 fsp,os-selection = <OS_SELECTION_LINUX>;
|
| /u-boot/doc/device-tree-bindings/exynos/ |
| A D | dwmmc.txt | 30 Drv/sample clock selection register of corresponding channel.
|
| /u-boot/board/freescale/p1010rdb/ |
| A D | README.P1010RDB-PA | 93 By default, don't set fsl_p1010mux:tdm_can, in this case, spi chip selection
128 CPLD NOR bank selection register address 0xFFB00009 Bit[0]:
169 1. Set POR switch selection register (addr 0xFFB00011) to 0.
|
| /u-boot/board/gdsys/mpc8308/ |
| A D | Kconfig | 98 prompt "FPGA flavor selection"
|
| /u-boot/doc/sphinx-static/ |
| A D | theme_overrides.css | 56 /* Menu selection and keystrokes */
|
| /u-boot/drivers/adc/ |
| A D | Kconfig | 59 - clock selection and prescaler
|
| /u-boot/lib/efi/ |
| A D | Kconfig | 40 prompt "EFI 32/64-bit selection"
|
| /u-boot/drivers/video/rockchip/ |
| A D | Kconfig | 2 # Video drivers selection for rockchip soc. These configs only impact the
|
| /u-boot/doc/board/kontron/ |
| A D | sl28.rst | 83 4 Clock generator selection bit 0
84 5 Clock generator selection bit 1
|