1Toshiba et8ek8 5MP sensor
2
3Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device
4
5More detailed documentation can be found in
6Documentation/devicetree/bindings/media/video-interfaces.txt .
7
8
9Mandatory properties
10--------------------
11
12- compatible: "toshiba,et8ek8"
13- reg: I2C address (0x3e, or an alternative address)
14- vana-supply: Analogue voltage supply (VANA), 2.8 volts
15- clocks: External clock to the sensor
16- clock-frequency: Frequency of the external clock to the sensor. Camera
17  driver will set this frequency on the external clock. The clock frequency is
18  a pre-determined frequency known to be suitable to the board.
19- reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor
20  is in hardware standby mode when the signal is in the low state.
21
22
23Optional properties
24-------------------
25
26- flash-leds: See ../video-interfaces.txt
27- lens-focus: See ../video-interfaces.txt
28
29
30Endpoint node mandatory properties
31----------------------------------
32
33- remote-endpoint: A phandle to the bus receiver's endpoint node.
34
35
36Example
37-------
38
39&i2c3 {
40	clock-frequency = <400000>;
41
42	cam1: camera@3e {
43		compatible = "toshiba,et8ek8";
44		reg = <0x3e>;
45		vana-supply = <&vaux4>;
46		clocks = <&isp 0>;
47		clock-frequency = <9600000>;
48		reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */
49		port {
50			csi_cam1: endpoint {
51				remote-endpoint = <&csi_out1>;
52			};
53		};
54	};
55};
56