1Lantiq XWAY SoC RCU reset controller binding
2============================================
3
4This binding describes a reset-controller found on the RCU module on Lantiq
5XWAY SoCs.
6
7This node has to be a sub node of the Lantiq RCU block.
8
9-------------------------------------------------------------------------------
10Required properties:
11- compatible		: Should be one of
12				"lantiq,danube-reset"
13				"lantiq,xrx200-reset"
14- reg			: Defines the following sets of registers in the parent
15			  syscon device
16			- Offset of the reset set register
17			- Offset of the reset status register
18- #reset-cells		: Specifies the number of cells needed to encode the
19			  reset line, should be 2.
20			  The first cell takes the reset set bit and the
21			  second cell takes the status bit.
22
23-------------------------------------------------------------------------------
24Example for the reset-controllers on the xRX200 SoCs:
25	reset0: reset-controller@10 {
26		compatible = "lantiq,xrx200-reset";
27		reg <0x10 0x04>, <0x14 0x04>;
28
29		#reset-cells = <2>;
30	};
31