1# SPDX-License-Identifier: GPL-2.0
2%YAML 1.2
3---
4$id: http://devicetree.org/schemas/serial/rs485.yaml#
5$schema: http://devicetree.org/meta-schemas/core.yaml#
6
7title: RS485 serial communications Bindings
8
9description: The RTS signal is capable of automatically controlling line
10  direction for the built-in half-duplex mode. The properties described
11  hereafter shall be given to a half-duplex capable UART node.
12
13maintainers:
14  - Rob Herring <robh@kernel.org>
15
16properties:
17  rs485-rts-delay:
18    description: prop-encoded-array <a b>
19    $ref: /schemas/types.yaml#/definitions/uint32-array
20    items:
21      items:
22        - description: Delay between rts signal and beginning of data sent in
23            milliseconds. It corresponds to the delay before sending data.
24          default: 0
25          maximum: 1000
26        - description: Delay between end of data sent and rts signal in milliseconds.
27            It corresponds to the delay after sending data and actual release
28            of the line.
29          default: 0
30          maximum: 1000
31
32  rs485-rts-active-low:
33    description: drive RTS low when sending (default is high).
34    $ref: /schemas/types.yaml#/definitions/flag
35
36  linux,rs485-enabled-at-boot-time:
37    description: enables the rs485 feature at boot time. It can be disabled
38      later with proper ioctl.
39    $ref: /schemas/types.yaml#/definitions/flag
40
41  rs485-rx-during-tx:
42    description: enables the receiving of data even while sending data.
43    $ref: /schemas/types.yaml#/definitions/flag
44
45  rs485-term-gpios:
46    description: GPIO pin to enable RS485 bus termination.
47    maxItems: 1
48
49additionalProperties: true
50
51...
52