1/* SPDX-License-Identifier: GPL-2.0-or-later */
2/*
3 * Copyright (C) 2001,2002,2003 Broadcom Corporation
4 */
5
6#include <asm/asm.h>
7#include <asm/regdef.h>
8#include <asm/mipsregs.h>
9#include <asm/stackframe.h>
10#include <asm/cacheops.h>
11#include <asm/sibyte/board.h>
12
13#define C0_ERRCTL     $26	      /* CP0: Error info */
14#define C0_CERR_I     $27	      /* CP0: Icache error */
15#define C0_CERR_D     $27,1	      /* CP0: Dcache error */
16
17	/*
18	 * Based on SiByte sample software cache-err/cerr.S
19	 * CVS revision 1.8.  Only the 'unrecoverable' case
20	 * is changed.
21	 */
22
23	.set	mips64
24	.set	noreorder
25	.set	noat
26
27	/*
28	 * sb1_cerr_vec: code to be copied to the Cache Error
29	 * Exception vector.  The code must be pushed out to memory
30	 * (either by copying to Kseg0 and Kseg1 both, or by flushing
31	 * the L1 and L2) since it is fetched as 0xa0000100.
32	 *
33	 * NOTE: Be sure this handler is at most 28 instructions long
34	 * since the final 16 bytes of the exception vector memory
35	 * (0x170-0x17f) are used to preserve k0, k1, and ra.
36	 */
37
38LEAF(except_vec2_sb1)
39	/*
40	 * If this error is recoverable, we need to exit the handler
41	 * without having dirtied any registers.  To do this,
42	 * save/restore k0 and k1 from low memory (Useg is direct
43	 * mapped while ERL=1). Note that we can't save to a
44	 * CPU-specific location without ruining a register in the
45	 * process.  This means we are vulnerable to data corruption
46	 * whenever the handler is reentered by a second CPU.
47	 */
48	sd	k0,0x170($0)
49	sd	k1,0x178($0)
50
51#ifdef CONFIG_SB1_CEX_ALWAYS_FATAL
52	j	handle_vec2_sb1
53	 nop
54#else
55	/*
56	 * M_ERRCTL_RECOVERABLE is bit 31, which makes it easy to tell
57	 * if we can fast-path out of here for a h/w-recovered error.
58	 */
59	mfc0	k1,C0_ERRCTL
60	bgtz	k1,attempt_recovery
61	 sll	k0,k1,1
62
63recovered_dcache:
64	/*
65	 * Unlock CacheErr-D (which in turn unlocks CacheErr-DPA).
66	 * Ought to log the occurrence of this recovered dcache error.
67	 */
68	b	recovered
69	 mtc0	$0,C0_CERR_D
70
71attempt_recovery:
72	/*
73	 * k0 has C0_ERRCTL << 1, which puts 'DC' at bit 31.  Any
74	 * Dcache errors we can recover from will take more extensive
75	 * processing.	For now, they are considered "unrecoverable".
76	 * Note that 'DC' becoming set (outside of ERL mode) will
77	 * cause 'IC' to clear; so if there's an Icache error, we'll
78	 * only find out about it if we recover from this error and
79	 * continue executing.
80	 */
81	bltz	k0,unrecoverable
82	 sll	k0,1
83
84	/*
85	 * k0 has C0_ERRCTL << 2, which puts 'IC' at bit 31.  If an
86	 * Icache error isn't indicated, I'm not sure why we got here.
87	 * Consider that case "unrecoverable" for now.
88	 */
89	bgez	k0,unrecoverable
90
91attempt_icache_recovery:
92	/*
93	 * External icache errors are due to uncorrectable ECC errors
94	 * in the L2 cache or Memory Controller and cannot be
95	 * recovered here.
96	 */
97	 mfc0	k0,C0_CERR_I		/* delay slot */
98	li	k1,1 << 26		/* ICACHE_EXTERNAL */
99	and	k1,k0
100	bnez	k1,unrecoverable
101	 andi	k0,0x1fe0
102
103	/*
104	 * Since the error is internal, the 'IDX' field from
105	 * CacheErr-I is valid and we can just invalidate all blocks
106	 * in that set.
107	 */
108	cache	Index_Invalidate_I,(0<<13)(k0)
109	cache	Index_Invalidate_I,(1<<13)(k0)
110	cache	Index_Invalidate_I,(2<<13)(k0)
111	cache	Index_Invalidate_I,(3<<13)(k0)
112
113	/* Ought to log this recovered icache error */
114
115recovered:
116	/* Restore the saved registers */
117	ld	k0,0x170($0)
118	ld	k1,0x178($0)
119	eret
120
121unrecoverable:
122	/* Unrecoverable Icache or Dcache error; log it and/or fail */
123	j	handle_vec2_sb1
124	 nop
125#endif
126
127END(except_vec2_sb1)
128
129	LEAF(handle_vec2_sb1)
130	mfc0	k0,CP0_CONFIG
131	li	k1,~CONF_CM_CMASK
132	and	k0,k0,k1
133	ori	k0,k0,CONF_CM_UNCACHED
134	mtc0	k0,CP0_CONFIG
135
136	SSNOP
137	SSNOP
138	SSNOP
139	SSNOP
140	bnezl	$0, 1f
1411:
142	mfc0	k0, CP0_STATUS
143	sll	k0, k0, 3			# check CU0 (kernel?)
144	bltz	k0, 2f
145	 nop
146
147	/* Get a valid Kseg0 stack pointer.  Any task's stack pointer
148	 * will do, although if we ever want to resume execution we
149	 * better not have corrupted any state. */
150	get_saved_sp
151	move	sp, k1
152
1532:
154	j	sb1_cache_error
155	 nop
156
157	END(handle_vec2_sb1)
158