1 // SPDX-License-Identifier: GPL-2.0-only
2 /**
3 * Copyright (C) 2006 Juergen Beisert, Pengutronix
4 * Copyright (C) 2008 Guennadi Liakhovetski, Pengutronix
5 * Copyright (C) 2009 Wolfram Sang, Pengutronix
6 *
7 * The Maxim MAX7300/1 device is an I2C/SPI driven GPIO expander. There are
8 * 28 GPIOs. 8 of them can trigger an interrupt. See datasheet for more
9 * details
10 * Note:
11 * - DIN must be stable at the rising edge of clock.
12 * - when writing:
13 * - always clock in 16 clocks at once
14 * - at DIN: D15 first, D0 last
15 * - D0..D7 = databyte, D8..D14 = commandbyte
16 * - D15 = low -> write command
17 * - when reading
18 * - always clock in 16 clocks at once
19 * - at DIN: D15 first, D0 last
20 * - D0..D7 = dummy, D8..D14 = register address
21 * - D15 = high -> read command
22 * - raise CS and assert it again
23 * - always clock in 16 clocks at once
24 * - at DOUT: D15 first, D0 last
25 * - D0..D7 contains the data from the first cycle
26 *
27 * The driver exports a standard gpiochip interface
28 */
29
30 #include <linux/module.h>
31 #include <linux/init.h>
32 #include <linux/platform_device.h>
33 #include <linux/mutex.h>
34 #include <linux/spi/max7301.h>
35 #include <linux/gpio/driver.h>
36 #include <linux/slab.h>
37
38 /*
39 * Pin configurations, see MAX7301 datasheet page 6
40 */
41 #define PIN_CONFIG_MASK 0x03
42 #define PIN_CONFIG_IN_PULLUP 0x03
43 #define PIN_CONFIG_IN_WO_PULLUP 0x02
44 #define PIN_CONFIG_OUT 0x01
45
46 #define PIN_NUMBER 28
47
max7301_direction_input(struct gpio_chip * chip,unsigned offset)48 static int max7301_direction_input(struct gpio_chip *chip, unsigned offset)
49 {
50 struct max7301 *ts = container_of(chip, struct max7301, chip);
51 u8 *config;
52 u8 offset_bits, pin_config;
53 int ret;
54
55 /* First 4 pins are unused in the controller */
56 offset += 4;
57 offset_bits = (offset & 3) << 1;
58
59 config = &ts->port_config[offset >> 2];
60
61 if (ts->input_pullup_active & BIT(offset))
62 pin_config = PIN_CONFIG_IN_PULLUP;
63 else
64 pin_config = PIN_CONFIG_IN_WO_PULLUP;
65
66 mutex_lock(&ts->lock);
67
68 *config = (*config & ~(PIN_CONFIG_MASK << offset_bits))
69 | (pin_config << offset_bits);
70
71 ret = ts->write(ts->dev, 0x08 + (offset >> 2), *config);
72
73 mutex_unlock(&ts->lock);
74
75 return ret;
76 }
77
__max7301_set(struct max7301 * ts,unsigned offset,int value)78 static int __max7301_set(struct max7301 *ts, unsigned offset, int value)
79 {
80 if (value) {
81 ts->out_level |= 1 << offset;
82 return ts->write(ts->dev, 0x20 + offset, 0x01);
83 } else {
84 ts->out_level &= ~(1 << offset);
85 return ts->write(ts->dev, 0x20 + offset, 0x00);
86 }
87 }
88
max7301_direction_output(struct gpio_chip * chip,unsigned offset,int value)89 static int max7301_direction_output(struct gpio_chip *chip, unsigned offset,
90 int value)
91 {
92 struct max7301 *ts = container_of(chip, struct max7301, chip);
93 u8 *config;
94 u8 offset_bits;
95 int ret;
96
97 /* First 4 pins are unused in the controller */
98 offset += 4;
99 offset_bits = (offset & 3) << 1;
100
101 config = &ts->port_config[offset >> 2];
102
103 mutex_lock(&ts->lock);
104
105 *config = (*config & ~(PIN_CONFIG_MASK << offset_bits))
106 | (PIN_CONFIG_OUT << offset_bits);
107
108 ret = __max7301_set(ts, offset, value);
109
110 if (!ret)
111 ret = ts->write(ts->dev, 0x08 + (offset >> 2), *config);
112
113 mutex_unlock(&ts->lock);
114
115 return ret;
116 }
117
max7301_get(struct gpio_chip * chip,unsigned offset)118 static int max7301_get(struct gpio_chip *chip, unsigned offset)
119 {
120 struct max7301 *ts = gpiochip_get_data(chip);
121 int config, level = -EINVAL;
122
123 /* First 4 pins are unused in the controller */
124 offset += 4;
125
126 mutex_lock(&ts->lock);
127
128 config = (ts->port_config[offset >> 2] >> ((offset & 3) << 1))
129 & PIN_CONFIG_MASK;
130
131 switch (config) {
132 case PIN_CONFIG_OUT:
133 /* Output: return cached level */
134 level = !!(ts->out_level & (1 << offset));
135 break;
136 case PIN_CONFIG_IN_WO_PULLUP:
137 case PIN_CONFIG_IN_PULLUP:
138 /* Input: read out */
139 level = ts->read(ts->dev, 0x20 + offset) & 0x01;
140 }
141 mutex_unlock(&ts->lock);
142
143 return level;
144 }
145
max7301_set(struct gpio_chip * chip,unsigned offset,int value)146 static void max7301_set(struct gpio_chip *chip, unsigned offset, int value)
147 {
148 struct max7301 *ts = gpiochip_get_data(chip);
149
150 /* First 4 pins are unused in the controller */
151 offset += 4;
152
153 mutex_lock(&ts->lock);
154
155 __max7301_set(ts, offset, value);
156
157 mutex_unlock(&ts->lock);
158 }
159
__max730x_probe(struct max7301 * ts)160 int __max730x_probe(struct max7301 *ts)
161 {
162 struct device *dev = ts->dev;
163 struct max7301_platform_data *pdata;
164 int i, ret;
165
166 pdata = dev_get_platdata(dev);
167
168 mutex_init(&ts->lock);
169 dev_set_drvdata(dev, ts);
170
171 /* Power up the chip and disable IRQ output */
172 ts->write(dev, 0x04, 0x01);
173
174 if (pdata) {
175 ts->input_pullup_active = pdata->input_pullup_active;
176 ts->chip.base = pdata->base;
177 } else {
178 ts->chip.base = -1;
179 }
180 ts->chip.label = dev->driver->name;
181
182 ts->chip.direction_input = max7301_direction_input;
183 ts->chip.get = max7301_get;
184 ts->chip.direction_output = max7301_direction_output;
185 ts->chip.set = max7301_set;
186
187 ts->chip.ngpio = PIN_NUMBER;
188 ts->chip.can_sleep = true;
189 ts->chip.parent = dev;
190 ts->chip.owner = THIS_MODULE;
191
192 /*
193 * initialize pullups according to platform data and cache the
194 * register values for later use.
195 */
196 for (i = 1; i < 8; i++) {
197 int j;
198 /*
199 * initialize port_config with "0xAA", which means
200 * input with internal pullup disabled. This is needed
201 * to avoid writing zeros (in the inner for loop),
202 * which is not allowed according to the datasheet.
203 */
204 ts->port_config[i] = 0xAA;
205 for (j = 0; j < 4; j++) {
206 int offset = (i - 1) * 4 + j;
207 ret = max7301_direction_input(&ts->chip, offset);
208 if (ret)
209 goto exit_destroy;
210 }
211 }
212
213 ret = gpiochip_add_data(&ts->chip, ts);
214 if (!ret)
215 return ret;
216
217 exit_destroy:
218 mutex_destroy(&ts->lock);
219 return ret;
220 }
221 EXPORT_SYMBOL_GPL(__max730x_probe);
222
__max730x_remove(struct device * dev)223 void __max730x_remove(struct device *dev)
224 {
225 struct max7301 *ts = dev_get_drvdata(dev);
226
227 /* Power down the chip and disable IRQ output */
228 ts->write(dev, 0x04, 0x00);
229 gpiochip_remove(&ts->chip);
230 mutex_destroy(&ts->lock);
231 }
232 EXPORT_SYMBOL_GPL(__max730x_remove);
233
234 MODULE_AUTHOR("Juergen Beisert, Wolfram Sang");
235 MODULE_LICENSE("GPL v2");
236 MODULE_DESCRIPTION("MAX730x GPIO-Expanders, generic parts");
237