1# SPDX-License-Identifier: GPL-2.0-only
2menuconfig MTD_SPI_NOR
3	tristate "SPI NOR device support"
4	depends on MTD
5	depends on MTD && SPI_MASTER
6	select SPI_MEM
7	help
8	  This is the framework for the SPI NOR which can be used by the SPI
9	  device drivers and the SPI NOR device driver.
10
11if MTD_SPI_NOR
12
13config MTD_SPI_NOR_USE_4K_SECTORS
14	bool "Use small 4096 B erase sectors"
15	default y
16	help
17	  Many flash memories support erasing small (4096 B) sectors. Depending
18	  on the usage this feature may provide performance gain in comparison
19	  to erasing whole blocks (32/64 KiB).
20	  Changing a small part of the flash's contents is usually faster with
21	  small sectors. On the other hand erasing should be faster when using
22	  64 KiB block instead of 16 × 4 KiB sectors.
23
24	  Please note that some tools/drivers/filesystems may not work with
25	  4096 B erase size (e.g. UBIFS requires 15 KiB as a minimum).
26
27choice
28	prompt "Software write protection at boot"
29	default MTD_SPI_NOR_SWP_DISABLE_ON_VOLATILE
30
31config MTD_SPI_NOR_SWP_DISABLE
32	bool "Disable SWP on any flashes (legacy behavior)"
33	help
34	  This option disables the software write protection on any SPI
35	  flashes at boot-up.
36
37	  Depending on the flash chip this either clears the block protection
38	  bits or does a "Global Unprotect" command.
39
40	  Don't use this if you intent to use the software write protection
41	  of your SPI flash. This is only to keep backwards compatibility.
42
43config MTD_SPI_NOR_SWP_DISABLE_ON_VOLATILE
44	bool "Disable SWP on flashes w/ volatile protection bits"
45	help
46	  Some SPI flashes have volatile block protection bits, ie. after a
47	  power-up or a reset the flash is software write protected by
48	  default.
49
50	  This option disables the software write protection for these kind
51	  of flashes while keeping it enabled for any other SPI flashes
52	  which have non-volatile write protection bits.
53
54	  If the software write protection will be disabled depending on
55	  the flash either the block protection bits are cleared or a
56	  "Global Unprotect" command is issued.
57
58	  If you are unsure, select this option.
59
60config MTD_SPI_NOR_SWP_KEEP
61	bool "Keep software write protection as is"
62	help
63	  If you select this option the software write protection of any
64	  SPI flashes will not be changed. If your flash is software write
65	  protected or will be automatically software write protected after
66	  power-up you have to manually unlock it before you are able to
67	  write to it.
68
69endchoice
70
71source "drivers/mtd/spi-nor/controllers/Kconfig"
72
73endif # MTD_SPI_NOR
74