1CONFIG_ARM=y 2CONFIG_TARGET_LS1046AFRWY=y 3CONFIG_TFABOOT=y 4CONFIG_SYS_TEXT_BASE=0x82000000 5CONFIG_NR_DRAM_BANKS=2 6CONFIG_ENV_SIZE=0x2000 7CONFIG_DM_GPIO=y 8CONFIG_QSPI_AHB_INIT=y 9CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y 10CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y 11CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-frwy" 12CONFIG_AHCI=y 13CONFIG_DISTRO_DEFAULTS=y 14CONFIG_FIT_VERBOSE=y 15CONFIG_OF_BOARD_SETUP=y 16CONFIG_USE_BOOTARGS=y 17CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=1550000.spi:1m(rcw),15m(u-boot),48m(kernel.itb);7e800000.flash:16m(nand_uboot),48m(nand_kernel),448m(nand_free)" 18CONFIG_MISC_INIT_R=y 19CONFIG_CMD_GPT=y 20CONFIG_CMD_I2C=y 21CONFIG_CMD_MMC=y 22CONFIG_CMD_NAND=y 23CONFIG_CMD_PCI=y 24CONFIG_CMD_USB=y 25CONFIG_CMD_CACHE=y 26CONFIG_MP=y 27CONFIG_MTDPARTS_DEFAULT="mtdparts=1550000.spi:1m(rcw),15m(u-boot),48m(kernel.itb);7e800000.flash:16m(nand_uboot),48m(nand_kernel),448m(nand_free)" 28CONFIG_OF_CONTROL=y 29CONFIG_ENV_OVERWRITE=y 30CONFIG_SYS_RELOC_GD_ENV_ADDR=y 31CONFIG_DM=y 32CONFIG_SATA_CEVA=y 33CONFIG_FSL_CAAM=y 34CONFIG_DM_I2C=y 35CONFIG_DM_MMC=y 36CONFIG_FSL_ESDHC=y 37CONFIG_MTD=y 38CONFIG_MTD_RAW_NAND=y 39# CONFIG_SPI_FLASH_BAR is not set 40CONFIG_SPI_FLASH_STMICRO=y 41# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set 42CONFIG_PHYLIB=y 43CONFIG_PHY_VITESSE=y 44CONFIG_PHY_GIGE=y 45CONFIG_E1000=y 46CONFIG_FMAN_ENET=y 47CONFIG_PCI=y 48CONFIG_DM_PCI=y 49CONFIG_DM_PCI_COMPAT=y 50CONFIG_DM_SCSI=y 51CONFIG_SYS_NS16550=y 52CONFIG_SPI=y 53CONFIG_DM_SPI=y 54CONFIG_FSL_QSPI=y 55CONFIG_USB=y 56CONFIG_DM_USB=y 57CONFIG_USB_XHCI_HCD=y 58CONFIG_USB_XHCI_DWC3=y 59CONFIG_USB_HOST_ETHER=y 60CONFIG_USB_ETHER_ASIX=y 61CONFIG_USB_ETHER_ASIX88179=y 62CONFIG_USB_ETHER_RTL8152=y 63CONFIG_RSA=y 64