1PHY nodes
2
3If the device tree is used to describe networking interfaces, U-Boot expects a
4node for each PHY.  Parent node for such a PHY node is expected to correspond to
5a MDIO bus and the bus is used to access the PHY.
6
7Required properties:
8
9 - reg : The ID number for the phy, usually a small integer
10
11Example:
12
13ethernet-phy@0 {
14	compatible = "ethernet-phy-id0141.0e90", "ethernet-phy-ieee802.3-c22";
15	interrupt-parent = <&PIC>;
16	interrupts = <35 IRQ_TYPE_EDGE_RISING>;
17	reg = <0>;
18
19	resets = <&rst 8>;
20	reset-names = "phy";
21	reset-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>;
22	reset-assert-us = <1000>;
23	reset-deassert-us = <2000>;
24};
25